Filter
Top Products
Pelco Manual C586M (9/99) 13
1. LED DISPLAY Displays the address of the multiplexer
(from 1-16) with which the keyboard is communicating.
2. LIVE/VCR KEY Selects the source of video to display
on the monitor(s). LIVE is live video from the cameras.
VCR is recorded video that is played back from a VCR.
The simplex multiplexer must be in the record mode to
record video. Check the main monitor screen to see that
it indicates REC. Press the LIVE/VCR key to change
modes.
3. ZOOM KEY Zooms in (2X or 4X) on the displayed
camera. Use the joystick to control the zoom location.
4. PIP KEY Displays on the main monitor a picture-in-
picture insert on top of the full-screen display. Multiplexer
must be in LIVE mode.
5. FOUR-CAMERA DISPLAY KEY Press once to
display a group of four cameras on the main monitor.
Repeat pressing to display other groups.
6. NINE-CAMERA DISPLAY KEY Press once to
display a group of nine cameras on the main monitor.
Press again to display second group.
7. 16-CAMERA DISPLAY KEY Press once to display all
16 cameras on the main monitor.
8. AUXILIARY KEYS Turn receiver auxiliary functions on
and off.
9. PRESET KEY Sends a camera to a preset: Enter the
preset number and then press this key.
10. PATTERN KEY Press to begin a pattern.
11. PTZ FUNCTION JOYSTICK Variable-speed,
vector-solving, bi-directional joystick for pan/tilt control.
Turbo pan* is achieved by full joystick deflection in either
pan direction. Twisting head for zoom control.
12. VIEW KEY Press and hold to enter programming mode
for multiplexer/multiplexer server.
13. LENS CONTROL KEYS Control camera lens iris and
focus functions.
14. SEQ KEY Starts/stops a sequence.
15. CLEAR KEY Press to clear a numeric entry.
16. CAM KEY Selects a camera: Enter the camera number
and then press this key.
17. NUMBER PAD Enter numbers.
18. MONITOR KEYS Select the main or spot monitor for
viewing individual cameras. A green LED above each key
indicates which monitor is selected.
19. UNIT KEY Selects the multiplexer with which the
keyboard communicates: Enter the address of the
multiplexer (1-16) and then press this key.
20. MONITOR Displays video on 5-inch (12.7 cm) screen.
21. SCREEN CONTROLS Adjust color and brightness.
Figure 7. KBD4000V Keyboard Definitions
For complete operational instructions, refer to Table C, Operation Guide. For programming instructions (not covered below),
refer to the
Programming
section.
KBD4000V
LIVE/VCR
UNIT MAIN SPOT SEQ VIEW PATTERN PRESET ON OFF
123
456
789
CAM 0 CLEAR
NEAR FAR
OPEN CLOSE
MADE IN U.S.A.
COLOR BRIGHTNESS
-+ -+
MONITOR
AUX
1234567 8
11
9
10
12
13
14
1516
17
21
18
19
20
*
THE TURBO PAN FEATURE
MAY BE DISABLED. PLACE
SWITCH 6 ON THE REAR
PANEL DIP SWITCH BLOCK
IN THE OFF POSITION. SEE
FIGURE 1.
*