Filter
Top Products
Pelco Manual C586M (9/99) 17
Table C. Operation Guide (Continued)
1. Press the SPOT MONITOR key. The green LED over
the SPOT key lights.
2. Select a camera on the multiplexer that you want to
sequence.
Addressing by Multiplexer (Switch 7 OFF)
a. On the number pad, press the address number of the
multiplexer (1-16 if the keyboard is connected to a
multiplexer; 1-8 if the keyboard is connected to a
server), then press the UNIT key. The LED displays
the address.
b. On the number keypad press the number of a
camera (1-16), then press the CAM key.
Addressing Consecutively (Switch 7 ON)
On the number keypad press the number of a camera,
then press the CAM key. Refer to Table D for camera
numbers.
3. Press the SEQ key.
1. Press the MAIN or SPOT MONITOR key.
2. On the number pad, press the address number of the
multiplexer (1-16 if the keyboard is connected to a
multiplexer; 1-8 if the keyboard is connected to a
server), then press the UNIT key. The LED displays the
address.
3. Press the SEQ key.
1. Select the desired multi-camera display.
2. Press and hold the multi-camera display key to enter
the multi-screen programming mode. A bar will appear
in the first camera location.
3. Use the joystick to move the on-screen bar to the
desired camera location for sequencing, and press
sequence key to initiate the sequencing of all active
cameras.
1. Hold down the SEQ key for approximately three
seconds.
OPERATION KEYBOARD COMMAND RESULT
(Continued on next page)
Starts the sequence of individual
cameras on the SPOT monitor.
Stops the sequence. The monitor
displays video from the camera on
which sequence stops.
The sequence will run until the
sequence key is pressed or until
another camera or multi-screen
display has been selected.
Starts sequencing the multiplexers
in numerical order, displaying the
main monitor first, then the spot
monitor. Monitors to be displayed
are selected in the Set Sequence
submenu of the Monitor menu of
the server. Sequencing appears on
the monitor affiliated with the
keyboard; for example, if the
keyboard is set for address 1, the
sequence will appear on monitor 1.
Run a sequence of
cameras from one
multiplexer on the
SPOT monitor. (SPOT
MONITOR DISPLAY in
the Advance System
Setup menu must be in
SEQUENCE.)
Stop a sequence of
cameras on a
multiplexer.
Sequence multiple
cameras in one
location of a 4-, 9-, or
16-camera display.
Sequence multiplexers
connected to a server.