Filter
Top Products
THE VIDEO EQUALIZER FUNCTION
34
En
THE VIDEO EQUALIZER FUNCTION
Rotating the channel equalizer dial normally applies equalizer effects on audio only. However, by using the VIDEO EQ function, effects
can be applied to video as well.
SET UP THE VIDEO EQ
1 Hold down the VIDEO EQ button.
This initiates the equalizer setup mode.
2 Touch each applicable button.
Touch each applicable button on the screen to operate the
VIDEO EQ setup.
• Whenever power is first turned on, default settings are as
follows:
HI: CONTRAST
MID: HUE
LOW: SATURATION
Whenever power is turned OFF, the unit returns to the above
status.
•Identical parameter values cannot be allocated to HI, MID
and LOW.
3Touch [EXIT].
This ends the equalizer setup mode.
TURNING THE EQUALIZER ON/OFF
1 Press the VIDEO EQ button.
The VIDEO EQ settings will alternate between enabled/
disabled each time the button is pressed.
HI
1 0
9
8
7
6
5
4
3
2
1
0
VIDEO EQ
VIDEO EQ SET UP Use to make the video effects change
simultaneously when using the equalizer.
OFF: Disables the VIDEO EQ.
R: Used when assigning parameters that
change the red elements of the VIDEO
EQ.
Used when assigning parameters.
G: Used when assigning parameters that
change the green elements of the VIDEO
EQ.
Used when assigning parameters.
B: Used when assigning parameters that
change the blue elements of the VIDEO
EQ.
CONTRAST: Used when assigning
parameters that change the contrast of
the VIDEO EQ.
HUE: Used when assigning parameters
that change the hue of the VIDEO EQ.
SATURATION: Used when assigning
parameters that change the saturation of
the VIDEO EQ.
SVM-1000_B_En.book 34 ページ ２００７年１１月２６日 月曜日 午後１２時５４分