Filter
Top Products
14
Creating a new Style
This function corrects the timing of the performance data in the
specified region.
1. In the “Style Edit Menu,” select “1. Quantize” and press
[ENTER].
The STYLE EDIT QUANTIZE screen will appear.
2. Use [ ] [ ] [ ] [ ] to move the cursor to the
parameter you want to change, and use the VALUE dial to
make the desired setting.
3. Select “EXECUTE” and then press [ENTER].
It is not possible to restore the data to its original state after
executing this operation.
This function erases performance data from the specified
region. The erased data will be converted to rests; the
measures themselves will remain.
1. In the “Style Edit Menu,” select “2. Erase” and press
[ENTER].
The STYLE EDIT ERASE screen will appear.
2. Use [ ] [ ] [ ] [ ] to move the cursor to the
parameter you want to change, and use the VALUE dial to
make the desired setting.
Correcting the note timing (Quantize)
Parameter Value Explanation
PART
ADrum, ABass,
Acc1–6, ALL
Selects the Style part to
which the Quantize
operation is to be applied.
CHORD Maj, min, 7th Selects the chord.
DIVISION
INT1–4,
MAIN1–4,
FILL1–4,
END1–4
Selects the division.
From
(MEAS:
BEAT: TICK)
0001: 01:
000–
Specifies the beginning of
the region to which
Quantize is to be applied.
To (MEAS:
BEAT: TICK)
0001: 01:
000–
Specifies the end of the
region to which Quantize
is to be applied.
Resolution
1/4, 1/8, 1/
8T, 1/16, 1/
16T,
1/32, 1/32T,
1/64
Specifies the timing
interval for quantization.
Select the shortest note
value used in the region to
be quantized.
Strength 0–100%
Specifies the amount of
timing correction applied
relative to the Resolution
timing interval.
If you select “100%,”
notes will be corrected all
the way to precise
intervals of the specified
Resolution.
With lower values, the
correction will not be as
tight, and with a setting of
0% there will be no
correction at all.
Note
Range Min
C– (Note
Range Max
value)
Specifies the lowest pitch
to be quantized.
Note
Range Max
(Note Range
Min value)–G9
Specifies the highest pitch
to be quantized.
Erasing unwanted data (Erase)
Parameter Value Explanation
PART
ADrum, ABass,
Acc1–6, ALL
Selects the Style part
from which data is to be
erased.
CHORD Maj, min, 7th Selects the chord.
DIVISION
INT1–4,
MAIN1–4,
FILL1–4,
END1–4
Selects the division.
From
(MEAS:
BEAT: TICK)
0001: 01: 000–
Specifies the beginning
of the region from which
data is to be erased.
To (MEAS:
BEAT: TICK)
0001: 01: 000–
Specifies the end of the
region from which data
is to be erased.
Parameter Value Explanation
Prelude_OM_Ver2.book Page 14 Wednesday, September 9, 2009 5:38 PM