Filter
Top Products
7
Editing an existing Style
You can change the Tone used by each part of a Style, and
adjust the volume and effect balance between parts.
The STYLE MAKEUP settings are applied to all divisions of a
Part for which the same Tone is assigned.
1. Select a Style (p. 25 in the owner’s manual).
2. Press [PART VIEW] a number of times to access the STYLE
MAKEUP screen.
You can’t access the STYLE MAKEUP screen during recording
or in recording-standby mode.
3. Use [ ] [ ] [ ] [ ] to select a parameter.
4. Turn the VALUE dial to edit the value.
Here’s how to change the effect settings or the amount of
chorus or reverb applied to the Style.
1. Select a Style (p. 25 in the owner’s manual).
2. Press [MENU] so the button is lit.
3. Use [ ] [ ] to select “Style Composer,” and press
[ENTER].
The STYLE COMPOSER screen will appear.
4. Press [2] (STYLE MFX).
The STYLE MFX screen will appear.
You can also access the STYLE MFX screen from the STYLE
COMPOSER screen by pressing [REVERB].
5. Use [ ] [ ] to select a page, and use [ ] [ ] to
select the parameter that you want to edit.
6. Turn VALUE to edit the value.
STYLE MFX screen
To access this screen, press [2] from the STYLE COMPOSER
screen or press [ ] from the STYLE MFX SETTING screen.
Changing the Style’s sounds
(STYLE MAKEUP)
Parameter
Value Explanation
PART
Switches between Makeup settings for the
Tones of each part. For example, if Accomp1
is using three Tones, here you can switch
among AC1 1, AC1 2, and AC1 3.
TONE
The Tone used by that part. The top line of the
screen shows the Tone number and Tone
name.
EXPRESS
-127–+127
Offset value for the
Expression assigned to the
Style
PANPOT
-127–+127
Offset value for the Panpot
assigned to the Style
REVERB
-127–+127
Offset value for the Reverb
assigned to the Style
CHORUS
-127–+127
Offset value for the Chorus
assigned to the Style
MUTE
OFF, ON
Specifies whether the sound
will be muted (ON) or heard
(OFF).
SOLO
OFF, ON
Specifies whether this part
alone will be heard by itself
(ON) or not (OFF).
Press [ ] [ ] to turn
this ON for the part at which
the cursor is located.
Changing the Style’s MFX
settings (STYLE MFX)
Parameter
Value Explanation
MFX Type
00–78
Select the MFX to use, and
edit the parameter values.
Refer to “Multi-Effects Parameters” (p. 56 in Owner’s
Manual).
Prelude_OM_Ver2.book Page 7 Wednesday, September 9, 2009 5:38 PM