Filter
Top Products
36
Creating a new song
This function transposes the pitches of the specified region.
1. In the “Song Edit Menu,” select “6. Transpose” and press
[ENTER].
The SONG EDIT TRANSPOSE screen will appear.
2. Use [ ] [ ] [ ] [ ] to move the cursor to the
parameter that you want to change, and use the VALUE
dial to make the desired settings.
3. Select “EXECUTE” and then press [ENTER].
It is not possible to restore the data to its original state after
executing this operation.
This function modifies the dynamics of the specified region.
1. In the “Song Edit Menu,” select “7. Change Velocity” and
press [ENTER].
The SONG EDIT CHANGE VELOCITY screen will appear.
2. Use [ ] [ ] [ ] [ ] to move the cursor to the
parameter that you want to edit, and use the VALUE dial to
set the value.
3. Select “EXECUTE” and then press [ENTER].
Shifting the pitch (Transpose)
Parameter Value Explanation
Part ALL, 1–16
Selects the Song part to
be transposed.
From
(MEAS:
BEAT: TICK)
0001: 01: 000–
Specifies the beginning of
the region to be
transposed.
To (MEAS:
BEAT: TICK)
0001: 01: 000–
Specifies the end of the
region to be transposed.
Value -127–127
Specifies the number of
semitones by which the
pitches are to be
transposed.
Note
Range Min
C–(Note Range
Max value)
Specifies the lowest pitch
to be transposed.
Note
Range Max
(Note Range
Min value)–G9
Specifies the highest pitch
to be transposed.
Modifying the note dynamics
(Change Velocity)
Parameter Value Explanation
Part ALL, 1–16
Selects the Song part whose
velocity is to be modified.
From
(MEAS:
BEAT: TICK)
0001: 01:
000–
Specifies the beginning of the
region whose velocity is to be
modified.
To (MEAS:
BEAT: TICK)
0001: 01:
000–
Specifies the end of the region
whose velocity is to be
modified.
Bias -99–99
Specifies the amount by which
the velocity is to be modified.
Magnify 0 –200%
Allows you to make the
velocity more uniform, or to
decrease or increase the
dynamics.
If Magnify is set near 0%, the
velocity will be adjusted
toward 64, and the Bias value
will be added to each velocity
value. This allows you to make
the velocity more consistent
while adjusting it as desired.
If Magnify is set to 101% or
higher, velocities greater than
64 will be increased while
velocities below 64 will be
decreased, increasing the
dynamics.
If Magnify is set to 100%, the
velocity will not change.
Note
Range Min
C–(Note
Range Max
value)
Specifies the lowest pitch
whose velocity is to be
modified.
Note
Range Max
(Note Range
Min value)–
G9
Specifies the highest pitch
whose velocity is to be
modified.
Prelude_OM_Ver2.book Page 36 Wednesday, September 9, 2009 5:38 PM