Filter
Top Products
100
Chapter 3. Creating Your Own Sounds
Delay R (Delay Time Right)
Adjust the time from the original sound until when the right
delay sound is heard.
Fbk (Feedback Level)
Adjust the proportion (%) of the delay sound that is fed back
into the effect. Negative (-) settings will invert the phase.
Mode (Feedback Mode)
Select the way in which delay sound is fed back into the
effect.
NORMAL:
The left delay sound will be fed back into the left
delay, and the right delay sound into the right delay.
CROSS:
The left delay sound will be fed back into the right
delay, and the right delay sound into the left delay.
Rate #
Adjust the speed of the modulation.
Depth
Adjust the depth of the modulation.
Phase
Adjust the spatial spread of the sound.
HF Damp
Adjust the frequency above which sound fed back to the
effect will be cut. If you do not want to cut the high
frequencies of the feedback, set this parameter to BYPASS.
LowGain
Adjust the gain of the low frequency range.
Hi Gain
Adjust the gain of the high frequency range.
Balance (Effect Balance) #
Adjust the volume balance between the direct sound and the
modulation delay sound. With a setting of D100:0W only the
direct sound will be output, and with a setting of D0:100W
only the modulation delay sound will be output.
Level (Output Level)
Adjust the output level.
19: TRIPLE-TAP-DELAY
The Triple Tap Delay produces three delay sounds; center,
left and right. The center delay time can be specified as a note
value of a specified tempo.
fig.3-64
Delay C (Delay Time Center)
Delay L (Delay Time Left)
Delay R (Delay Time Right)
Adjust the time delay from the direct sound until when the
delay sound is heard. This parameter can be set as a note-
value of a specified tempo. In this case, specify the value of
the desired note.
Fbk (Feedback Level) #
Adjust the proportion (%) of the delay sound that is fed back
into the effect. Negative (-) settings will invert the phase.
Level C (Center Level)
Level L (Left Level)
Level R (Right Level)
Adjust the volume of each delay sound.
HF Damp
Adjust the frequency above which sound fed back to the
effect will be cut. If you do not want to cut the high
frequencies of the feedback, set this parameter to BYPASS.
LowGain
Adjust the gain of the low frequency range.
Hi Gain
Adjust the gain of the high frequency range.
Balance (Effect Balance) #
Adjust the volume balance between the direct sound and the
delay sound. With a setting of D100:0W only the direct sound
will be output, and with a setting of D0:100W only the delay
sound will be output.
L in
R in
L out
R out
Left Tap
Right Tap
Triple Tap Delay
2-Band
EQ
2-Band
EQ
Balance W
Balance D
Balance W
Balance D
Feedback
Center Tap
When Step Rate is Set as a Note Value
As the specified tempo, you may use either the Patch
Tempo, Performance Tempo, or the tempo clock of the
XP-30’s system.
If you want to use a fixed tempo in Patch mode (Tempo
parameter setting), set the Source parameter (PATCH/
COMMON/PATCH CLOCK) to PATCH and set the
desired tempo.
If you want to use the system’s tempo clock in Patch
mode, set the Source parameter (PATCH/COMMON/
PATCH CLOCK) to SYSTEM.
If you want to use a fixed tempo in Performance mode
(Tempo parameter setting), set the Source parameter
(PERFORM/COMMON/PERFORM CLOCK) to
PERFORM and set the desired tempo.
If you want to use the system’s tempo clock in
Performance mode, set the Source parameter
(PERFORM/COMMON/PERFORM CLOCK) to
SYSTEM.