Filter
Top Products
26
Getting Ready
Turning On the Power
1
Before you turn the power on, check to make sure that:
• All external devices are correctly connected to the XP-30.
• The volume controls of the XP-30 and the amp/mixer system are turned
down all the way.
2
Turn on the power switch located on the rear panel of the XP-
30.
fig.Q-06
3
Turn the power on of your amp or audio system.
4
Play the XP-30 and gradually raise the volume controls of the
XP-30, your amp or mixer to an appropriate volume level.
fig.Q-07
■ Turning Off the Power
1
Before you turn power off, check to make sure that:
• The volume controls of the XP-30 and the amp/mixer system are turned
down all the way.
• Important data has been saved to a memory card (p. 122).
2
Turn off your amp/mixer system.
3
Turn off the XP-30 power.
Once the connections have
b
een completed (p. 24),
turn on power to your
various devices in the order
specified. By turning on
devices in the wrong order,
you risk causing
malfunction and/or
damage to speakers and
other devices.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
b
efore the unit will operate
normally.
Be careful not to raise the
VOLUME slider of the XP-
30 too much. Excessive
volume may damage your
amp/speaker system or
could cause hearing