Filter
Top Products
143
Appendices
Quick Reference of Procedures
The XP-30 has a large number of functions. This section gives
the procedures for using some of the frequently-used
functions. For functions that are used simply by setting the
applicable parameter, only the “Parameter name (mode/
display group/display)” is listed.
* “[A] + [B]” indicates that you are to hold down [A] and press
[B].
■ Patch Mode
Selecting the Patch Mode PLAY Display
Press [PATCH].
Selecting a Patch
Use the VALUE dial, [INC]/[DEC], or numeric keys to select.
Using the Numeric Keys to Select the
Patch Group
Press [SHIFT] + numeric keys.
Selecting Patches Using the Digit Hold
Function
1. Press [SHIFT] + [ENTER] (turn on the Digit Hold
function).
2. Use the numeric keys to specify the number of the one’s
place.
* To turn off the Digit Hold function, press [SHIFT] + [ENTER]
once again.
Transposing the Keyboard by Octave
Press [-OCT] or [+OCT].
Transposing the Keyboard in Semitone
Steps
Transpose on/off: press [TRANSPOSE]
Lower the keyboard: press [TRANSPOSE] + [-OCT]
Raise the keyboard: press [TRANSPOSE] + [+OCT]
Modifying a Patch (basic procedure)
1. Make the [EDIT] indicator light.
2. Use the function buttons to select the display group.
3. Use [ ]/[ ] to select the desired display page.
4. Turn off the [EDIT] indicator.
5. Use TONE SELECT [1]–[4] (function buttons) to select
the Tone.
6. Use [ ]/[ ] to select a parameter.
7. Use the VALUE dial, [INC]/[DEC], or the numeric keys
to modify the value.
* If you wish to move to a different parameter group, turn on the
[EDIT] indicator.
Changing the Patch Assigned to a
Performance
1. Press [PERFORM] + [PATCH].
2. Use [ ]/[ ] to select a Part.
3. Use the VALUE dial, [INC]/[DEC], or the numeric keys
to select a Patch.
The rest is the same as for the basic procedure listed above.
Simultaneously Modifying the Values
of Two or More Tones
In a Tone setting display, hold down the TONE SELECT [1]–
[4] (function button) for one Tone, and press the button(s) for
the other Tone(s) you want to edit.
Adjusting the Volume of a Patch
Level parameter (PATCH/COMMON/PATCH COMMON)
Adjusting the Pan Position of a Patch
Pan parameter (PATCH/COMMON/PATCH COMMON)
■ Performance Mode
Selecting the Performance Mode PLAY
Display
Press [PERFORM].
Selecting a Part to Play from the
Keyboard (for a Single-Type
Performance)
Use [ ]/[ ].
Changing the Patch/Rhythm Set
Assigned to a Part
1. Press [PERFORM] + [PATCH].
2. Use [ ]/[ ] to select a Part.
3. Use the VALUE dial, [INC]/[DEC], or the numeric keys
to select a Patch or Rhythm Set.
Using the Numeric Keys to Select the
Performance/Patch/Rhythm Set Group
Press [SHIFT] + numeric keys.