Filter
Top Products
Working with User Programs
50
Selecting a User Program
Though the User Program memory you specified above is already selected, there will be times when you
need to select another memory. In that case, here is what you need to do:
(1) Briefly press [USER PROGRAM/WRITE]. Do
not hold this button down because doing
so will start the Write procedure (see
above).
The User Program field now indicates the
number of the User Program you selected
last, or “11” if you have not yet selected a
User Program since switching on the
EM-55 OR. The important thing to note
here is the “Edit” message.
It indicates that the EM-55 OR is still using
the last manual changes you may have
made before selecting the User Program
function. The User Program number there-
fore only means “this is the last memory
you selected”.
None of its settings are being used for the
time being. By pressing [USER PROGRAM/
WRITE] again, you can leave the User Pro-
gram mode without changing your manual
settings. This may be important to remem-
ber if you were about to write your settings
and accidentally pressed the wrong button
(or didn’t press it long enough).
To actually select a User Program…
(2) Press one numeric button [1]~[8] to select
the bank.
(3) Press another (or the same) numeric but-
ton [1]~[8] to select the memory.
The settings of the selected User Program
will be recalled.
Note: As soon as you modify any setting (on the
front panel or in the FUNCTION menu), the “Edit”
message appears next to the User Program number.
(4) Once again press [USER PROGRAM/
WRITE] to leave the User Program mode.
Note: You can also press [STYLE] and [TONE] to
leave this mode.
USER
PROGRAM
WRITE
EM-55OR_UK Page 50 Wednesday, July 10, 2002 3:32 PM