Filter
Top Products
34
Deleting a Pattern
1. Press the [PATTERN SELECT] button so the button
is lit.
The display will indicate “Ptn” and the pads that have
been recorded will blink.
2. Press the [DEL] button so the button is lit.
The display will indicate “dEL.”
If the display indicates “
ENP,” that bank does not contain
any pads to which a pattern is assigned.
3. Press a bank button and a pad to specify the bank
and pad of the pattern you want to delete.
The selected pad will light, and the [DEL] button will blink.
MEMO
• Nothing will happen if you press a pad to which no
pattern is assigned (i.e., a pad that is not lit).
• You can simultaneously select more than one pad if
they are in the same bank.
• If you specify a bank that’s protected (p. 38), the display
will indicate “
Prt” (Protected) and you won’t be able
to delete a pattern.
• If you decide not to delete a pattern, press the
[CANCEL] button.
4. Press the [DEL] button to carry out the deletion.
During this process, the [DEL] button will change from
blinking to lit, and the dot in the display will blink. When
the dot stops blinking, deletion has been completed.
NOTE
Never turn o the power while the dot is blinking.
Doing so may destroy the SD card.
Deleting All Patterns
Here’s how to delete the patterns of all banks in a single
operation.
1. Press the [PATTERN SELECT] button so the button
is lit.
The display will indicate “Ptn,” and pads that are recorded
will blink.
2. While holding down the [CANCEL] button, press
the [DEL] button.
The display will indicate “dAL,” and the [DEL] button will
light. The [BANK] buttons will blink.
3. Press one of the [BANK] buttons.
MEMO
• If protection is in eect (p. 38), “Prt” (Protected) will
be displayed, and you won’t be able to carry out the
deletion.
• If you decide not to delete the patterns, press the
[CANCEL] button.
4. Press the [DEL] button to carry out the deletion.
During this process, the [DEL] button will change from
blinking to lit, and the dot in the display will blink. When
the dot stops blinking, the deletion has been completed.
NOTE
Never turn o the power while the dot is blinking.
Doing so may destroy the SD card.
Exchanging the Patterns of Two
Pads
By exchanging patterns between two pads, you can
change the way in which patterns are assigned to the
pads.
MEMO
If you decide to cancel this operation during the
procedure, press the [CANCEL] button.
1. Press the [PATTERN SELECT] button so the button
is lit.
The display will indicate “Ptn.”
2. Exchange the patterns, using the procedure
described in “Exchanging Samples between Two
Pads” (p. 31).
In the procedure, read “pattern” wherever the explanation
says “sample.”
Copying a Pattern to Another
Pad
You can copy a pattern from one pad to another pad. This
lets you create a new pattern based on an existing pattern.
MEMO
If you decide to cancel this operation during the
procedure, press the [CANCEL] button.
1. Press the [PATTERN SELECT] button so the button
is lit.
The display will indicate “Ptn.”
2. Copy the patterns, using the procedure described
in “Copying a Sample to Another Pad” (p. 31).
In the procedure, read “pattern” wherever the explanation
says “sample.”