Filter
Top Products
The Velocity Curve (p. 24) and layer (p. 17) settings do not affect the pedal hi-hat sound.
Control the effect applied to an Instrument (EFS)
When this function is assigned, the hi-hat control pedal will control the effect send level of an
Instrument. When the pedal is released, the pad takes the values set for the pad (values set in FX
SEND). When the pedal is depressed, the effect send level will be increased proportionally to the angle
of the pedal.
Control Instrument pitch (U07/U12/U24/d05/d12/d24)
When this function is assigned, the hi-hat control pedal will control the pitch of an Instrument. When
the pedal is released, the pad takes the pitch set for the pad. When the pedal is depressed, the pitch will
be modified proportionally to the angle of the pedal.
U07 up 700 cents (a perfect fifth)
U12 up 1,200 cents (one octave)
U24 up 2,400 cents (two octaves)
d05 down 500 cents (a perfect fourth)
d12 down 1,200 cents (one octave)
d24 down 2,400 cents (two octaves)
Depending on the type of Instrument or on the sound parameter pitch settings, there may be a point
above which the pitch cannot be raised.
Adjusting the Volume of the Pedal Hi-Hat Sound (PDL LEVEL)
When one of the Hi-Hat Cymbals for pedal control (H01–H17) sounds is assigned to the pad, you can
control the pedal hi-hat volume when the hi-hat control pedal is pressed. Higher values will result in a
louder sound. At a setting of 0, there will be no sound.
1
In the Edit mode, select the FX/PEDAL parameter group.
2
Use [ ] or [ ] to select PDL LEVEL.
3
Use PATCH/VALUE [-] or [+] to set the volume (0–15).
INT1 INT2 INT3 INT4 INT5 INT6 INT7 INT8
TRIG1 TRIG2 TRIG3 TRIG4 TRIG1 TRIG2 TRIG3 TRIG4
TRIG1 TRIG2 TRIG3 TRIG4 TRIG1 TRIG2 TRIG3 TRIG4
(Head) (Head) (Head) (Head) (Rim) (Rim) (Rim) (Rim)
INT1 INT2 INT3 INT4 INT5 INT6 INT7 INT8
(Head) (Head) (Head) (Head) (Rim) (Rim) (Rim) (Rim)
Pad Bank A
Pad Bank B
high priority
low priority
INT 1: Internal pad 1
TRIG 1: Trigger input 1
NOTE
NOTE
55
1
2
3
4
5