Filter
Top Products
127
Troubleshooting
Appendices
Problems with Internal
Memory
Data Was not Saved Correctly in
Internal Memory
It is possible that the power was turned off while
data was being written into internal memory.
The lost data cannot be recovered. In this case, it is possible
that all of the internal memory data may be damaged. If
you continue using the SPD-S in this state, further
malfunctions may occur. Please initialize the internal
memory. When you initialize, all data in internal memory
will be lost.
Problems with a Memory
Card
Data Was not Saved Correctly in a
Memory Card
It is possible that the power was turned off while
data was being written into the memory card.
The lost data cannot be recovered. In this case, it is possible
that the data of the entire memory card has been damaged.
If you continue using the SPD-S in this state, further
malfunctions may occur. Please format the memory card.
When you format, all data in the memory card will be lost.
An Inserted Memory Card Is not
Detected
Can’t Select Data from a Memory
Card
Is the memory card inserted correctly?
After the shutdown operation, remove the memory card,
then re-insert the memory card correctly. (p. 23)
Is the memory card an appropriate type?
The SPD-S can use 16 MB–512 MB (3.3V) CompactFlash
memory cards. Other types cannot be used.
Is the memory card formatted correctly?
Only memory cards that have been formatted by the SPD-S
can be used. Please format the memory card. (p. 67)
Problems When Using an
External Pad
No Sound
Is InputMode set appropriately?
If using two pads, set it to TRGx2.
If using a pad with the rim-shot feature, set it to HD&RM.
To use the rim-shot/edge-shot/bell-shot features, connect a
pad using a stereo cable that comes with the pad product. In
this case, you can connect one pad only. (p. 80)
The Volume Cannot Be Properly
Controlled Through Strike Intensity
Is Trig Type set appropriately?
Specify the trigger type according to the pad in use. Adjust
Sensitivity and VeloCurve. (p. 77, p. 81, p. 83)
A Sound Is not Produced with a
Weak Strike
Is the Threshold value too large?
Set Threshold to an appropriate value. (p. 81)
When Striking Repeatedly, some
Sounds Are Lost
Is Trig Type set appropriately?
Make the trigger type match. In some cases, when using
pads or acoustic drum triggers from other manufacturers,
you should make your settings in Scan Time or other
parameters. (p. 80)
SPDS_e.book 127 ページ ２００４年４月１９日 月曜日 午前９時５８分