Filter
Top Products
35
Chapter 1 Making a performance/Creating a patch
Chapter 1
When Wave SW is set to anything but OFF, the following screens for selection of an item for Waves A and B are displayed:
When Wave SW is not set to OFF, set the following parameters as well.
If you change the value in Level or Pan during sound production, the sound is stopped.
If you press [FUNC] while editing the three parameters above, the screen is switched between the wave A and B screens.
When Wave SW is set to VELO, set the following parameter as well.
Parameter Value Descriptions
B
(Wave)
I
000 (OFF),
I
001–399,
C
001–500
Specify the wave number assigned to wave B.
I
000 (OFF): Selected when you want no sound to be produced
I
001–399: Internal memory
C
001–500: Memory card
* By pressing [CARD], you can select the top number of the internal memory or of the
memory card.
B Level 0–127 Set the volume of wave B.
B Pan L15–CENTER–R15,
RANDOM
Set the pan position (left-right balance) of wave B. If set to RANDOM, the pan position
varies each time the sound is reproduced.
Parameter
Value Descriptions
VeloSWPoint
(Velocity
Switch Point)
2–127 Set the threshold level. When the velocity is equivalent to or above this value, wave B is reproduced.
* The velocity here refers to the value of the strike force expressed on a scale of 1 to 127.
If you hold down [SHIFT] and press [FUNC], the parameter is reset to its initial value.
If you hold down [SHIFT] and press [ENTER], the parameter is copied to all other pads/triggers.
SPDS_e.book 35 ページ ２００４年４月１９日 月曜日 午前９時５８分