Filter
Top Products
72
Chapter 6 Using a CompactFlash Memory Card
BACKUP LOAD
Here's how to load backup data (SPD-S settings: patch, wave, setup) from a memory card.
Once you execute this operation, the loaded backup data will replace the settings currently within the SPD-S.
1.
Set the following parameter.
Press the PAGE buttons to change parameters and press [-]/[+] to change the value.
When Load was set to "1–4" in Step 1
2.
Press [>] so that “load, sure?” appears. Press [ENTER] to load the backup data selected in Load in Step
1.
While loading is in progress, “now processing..” is displayed. Afterwards, the SPD-S returns to the patch mode.
Do not power the unit off during execution.
When Load was set to "One Wave" in Step 1
2.
Set the following parameters as well.
Press the PAGE buttons to change parameters and press [-]/[+] to change the value.
3.
Press [>] so that “load wave, sure?” appears. Press [ENTER] to load the wave selected in Src in Step 1.
Do not power the unit off during execution.
4.
A “continue?” indication appears. If you press [ENTER], the SPD-S returns to the “Src” screen as in
Step 1, where you can continue your operation. If you press [EXIT], the SPD-S returns to wave mode.
Icon Description
New (empty) backup data (will not load)
Previously saved backup data
Parameter
Value Descriptions
Load
1–4,
One Wave
1–4: To choose a set of backup data stored on a card.
One Wave: Selecting an individually stored wave in the backup data.
Parameter
Value Descriptions
Src
(Source)
1001–1399,
2001–2399,
3001–3399,
4001–4399
Select the wave number(s) to be loaded from the backup data on a card. The left most digit
represents the backup data set number. The bottom three digits (001 to 399) represent the
wave number contained in the backup data set.
* Press [FUNC] and [-]/[+] to move to the beginning of the backup data set.
Dst
(Destina-
tion)
I
001–399,
C
001–500
Select the wave number to which the wave is loaded. The initial value is the top number of
the new (empty) waves.
I
001–399: To the internal memory
C
001–500: To the memory card
* By pressing [CARD], you can select the top number of the internal memory or of the
memory card.
* If you hold down [SHIFT] and press [FUNC], a new (empty) wave number is selected.
* While continuing to hold down [FUNC], the remaining capacity of the memory (“Re-
main”) is indicated.
SPDS_e.book 72 ページ ２００４年４月１９日 月曜日 午前９時５８分