Filter
Top Products
53
Chapter 3 Sampling
Chapter 3
Sampling Methods
Two sampling modes are available.
Patch mode:
• For using a sampled sound immediately after sampling it
*A sampled wave can be directly assigned to a patch.
Wave mode:
• For sampling with wave numbers selected in advance
• For sampling multiple sounds in succession
• For sampling a sound that won’t immediately be used in
performance (for recording and storing waves)
Basic Sampling Operations
Before sampling, take the following steps.
1
Turn the INPUT LEVEL knob on the rear panel to the minimum (MIN)
position.
2
Connect a sound source (microphone/CD player, etc.) to the INPUT
jack(s) on the rear panel. (p. 20)
3
Turn the MIC/LINE switch in accordance with the device connected in
Step 2.
When a microphone is connected, switch it to
MIC
.
When a CD player or an electronic instrument is connected, switch it to
LINE
.
4
Power up the device connected in Step 2.
5
Switch on the power of SPD-S. (p. 22)
To prevent malfunction and/
or damage to speakers or other
devices, always turn down the
volume, and turn off the
power on all devices before
making any connections.
SPDS_e.book 53 ページ ２００４年４月１９日 月曜日 午前９時５８分