Filter
Top Products
16
Getting ready to play
1. Attach the included sound module mounting plate to
the TD-9.
Use the included wing bolts to attach the plate as shown in
the illustration.
* Use only the included wing boits. Using any other nuts
may cause malfunction.
* You must use the TD-9 with the sound module mounting
plate installed.
• When turning the unit upside-down, get a bunch of
newspapers or magazines, and place them under the four
corners or at both ends to prevent damage to the buttons
and controls. Also, you should try to orient the unit so no
buttons or controls get damaged.
• When turning the unit upside-down, handle with care to
avoid dropping it, or allowing it to fall or tip over.
2. Attach the TD-9 (with the sound module mounting
plate installed) to your drum stand (such as the MDS-
9; available separately).
3. Connect the included cable to the TD-9’s TRIGGER
INPUT connector, and connect your pads and
pedals.
Labels indicating the pad to be connected are attached to
the cable.
Connect the pads and pedals as shown in the illustration.
• If you don’t connect a pad to each of the cables, make the
following settings for unconnected pads in order to prevent
malfunction.
- Turn the instrument’s Group setting OFF (p. 25).
- In the pad’s MIDI settings, turn the NOTE NUMBER
setting OFF (p. 32).
• When using any other cymbal pads than CY-12R/C or CY-
15R, no need to connect the “RDB” cable to the cymbal
pad. Keeping the cap on top of the “RDB” cable plug,
please fasten it up on the stand so that it does not disturb
your playing.
Mounting the TD-9 on the Stand
T3
T2
CR1
HH
SNR
HHC
KIK
TD-9
T1
RD
RDB
TD-9_e.book 16 ページ ２００８年１月２３日 水曜日 午後４時２４分