Filter
Top Products
53
MIDI-related settings
MIDI settings for precise expressiveness in performances [F2] (CTRL)
Parameter value Description
PedalCC
OFF,
MODULATION(1),
FOOT(4),
GENERAL1(16)
Specifies the MIDI control change message used to transmit/receive the depth to
which the hi-hat pedal is pressed.
HH
Compatibility
TD-9/TD-20,
EXTERNAL
This is a setting for the MIDI messages transmitted when you’re using an external MIDI
sound module to sound the notes played by the TD-9 and pads.
TD9/TD20:
Choose this setting if you’re using just the TD-9 and pads, or if you’re using a TD series
unit such as the TD-9 or TD-20 as your MIDI sound module.
MIDI messages appropriate for the TD series will be transmitted.
EXTERNAL:
Choose this setting if you’re using an external MIDI sound module other than the TD
series.
If you choose this setting, the display will indicate “HH Note# Border.”
HH
Note# Border
0–127
This setting lets you transmit MIDI messages that are appropriate for the MIDI sound
module you're using.
The note number transmitted when you strike the hi-hat will change depending on the
amount of pressure on the hi-hat pedal.
HH Border allows you to adjust the pedal position at which the note number switches
from the open hi-hat to the closed hi-hat.
As you monitor the note number transmitted by the TD-9 and the Control Change mes-
sage value, adjust the setting until the note number is switched at the pedal position
you want.
When using a VH-11 for the hi-hat, setting this value to around 80 allows you to trans-
mit the closed hi-hat note
number when the pedal is slightly above the fully depressed position.
If you change the HH Border setting, the hi-hat of a pattern that was recorded
onto the internal sequencer by playing the pads may play back in a way that is
different from the actually recorded performance.
TD-9_e.book 53 ページ ２００８年１月２３日 水曜日 午後４時２４分