Filter
Top Products
48
Storing Your Favorite Settings (Favorites)
When you execute this operation, all favorites stored in the VR-700
and the values of system parameters that can be edited in Function
mode will be backed up to USB memory.
1.
Connect your USB memory to the rear panel USB
MEMORY connector (p. 22).
2.
Press the FAVORITE [FILE SAVE] button.
3.
Use the [+] button or [–] button to specify the backup
number.
You can create up to 99 backups (numbered 01–99) on a single USB
memory device.
* If you specify a number for which a backup already exists, the
decimal point at the right edge of the display will light.
* If USB memory is not correctly inserted, the display will indicate
.
4.
When you’ve specified the backup number, press the
[FUNCTION/ENTER] button.
Backup to USB memory will begin.
* If you decide not to execute the Backup operation, press the
[DISPLAY/EXIT] button.
* If a backup already exists at the number you’ve specified,
will appear in the display. If you’re sure that you don’t mind
overwriting the existing backup, press the [FUNCTION/ENTER]
button.
If instead you want to select a different number, press the [DISPLAY/
EXIT] button.
Do not switch off the VR-700’s power while the backup is being
executed.
5.
When the backup is completed, the display will return to
its previous state.
When you execute this operation, the 64 favorites and the system
parameters will be restored into the VR-700’s memory from the USB
backup.
You can choose whether to restore the 64 favorites and system
parameters together, or to restore only the 64 favorites and leave
the system parameters as they were.
When you execute this operation to restore from USB memory,
the 64 favorites currently in the VR-700’s internal memory and
its Function mode system parameters will be erased
(overwritten by the restored data). This data cannot be
recovered, so we recommend that you back it up before you
proceed (p. 48).
1.
Connect your USB memory to the rear panel USB
MEMORY connector (p. 22).
2.
Press the FAVORITE [FILE LOAD] button.
3.
Use the [+] button or [–] button to select the desired
backup number.
* If USB memory is not correctly inserted, the display will indicate
.
4.
If you want to restore both the favorites and the system
parameters, press the [FUNCTION/ENTER] button.
If you want to restore only the favorites, hold down the
[BANK] button and press the [FUNCTION/ENTER] button.
* If you decide not to execute the Restore operation, press the
[DISPLAY/EXIT] button.
Do not switch off the VR-700’s power while the restoration is
being executed.
5.
When the restoration is completed, the display will
return to its previous state.
Backing up Favorites to USB
Memory
Restoring from USB Memory
VR-700_e.book 48 ページ ２００９年１１月１８日 水曜日 午前９時２４分