Sanyo DSR-3000 Recording Equipment User Manual


 
NETWORK SET SETTING
Network connection
Insert a recommended PCMCIA-compatible Ethernet card into the PC card slot at the rear of the digital video recorder.
This will enable you to view images on this unit and make menu settings through the network (LAN) from a personal computer. ID1,
ID2 or ID3 and passwords are required.
Note:
Up to four computers can be connected simultaneously to the DVR main unit. However, if four computers are already connected
and then another computer is connected at a user level that is higher than the user levels that are currently being used, any users
who are logged on at lower levels will be forcibly logged off, and the computer being connected at the higher level will have priority.
If all four computers that are already connected are connected at user level ID1, the last user to connect will be disconnected.
The PC card slot is for 16 bit 5 V cards only. Do not use 32 bit card bus types of card, as they may damage the PC card slot of the
digital video recorder.
<NETWORK SET>
LAN CARD : LAN1
NETWORK CONTROL : OFF
IP ADDRESS : 192.168. 0. 1
SUBNET MASK : 255.255.255. 0
GATEWAY : 0. 0. 0. 0
PORT : 00080
ID : PASSWORD (4-8)
ID1 : 1111----
ID2 : 2222----
ID3 : 3333----
Main menu 2 Sub-menus
Sets LAN card.
Sets NETWORK control.
Enter IP ADDRESS.
Enter SUBNET MASK.
Enter GATEWAY.
Sets the port.
Sets the three levels of user passwords.
<MAIN MENU 2>
1.DISPLAY/VIDEO LOSS SET ->
2.RS-232C/RS-485 SET ->
3.BUZZER SET ->
4.SECURITY LOCK SET ->
5.NETWORK SET ->
6.HDD SET ->
7.POWER FAILURE/USED TIME ->
TO MAIN MENU 1 ->
MOVE LINES WITH JOG. SELECT WITH SHUTTLE
6
2
10
14
5
1
9
13
7
3
11
15
8
4
12
16
1
2
3
6
2
10
14
5
1
9
13
7
3
11
15
8
4
12
16
1
2
3
1 – 16
Main monitor
DIGITAL IN DIGITAL OUT
DIGITAL IN DIGITAL OUT
• When connecting directly to the computer
(without using an Ethernet hub)
• When connecting via an intranet (using an Ethernet hub)
Ethernet switching hub
TV monitor
(sold separately)
Computer
STP (shielded twisted pair) Cable
(straight-type CAT-5, 3 m or less)
STP (shielded twisted pair) Cable
(straight-type CAT-5, 3 m or less)
1 – 16
Main monitor
DIGITAL IN DIGITAL OUT
DIGITAL IN DIGITAL OUT
TV monitor
(sold separately)
Computer
Computer
Always use a cross-type
Ethernet cable.
Always use a straight-
type Ethernet cable.
Ethernet switching hub
Intranet
2
3
1
1
3
2
(Installed) (Removed)
Locking can be carried out
easily by sliding the knob.
Return the knob after
unlocking.
Inserting the recommended LAN card
66
English