Filter
Top Products
18
EN
Setting Up the Operating Environment
Rehearsal mode setting (RHSL)
This setting lets you determine whether the volume
will increase or decrease after the locate point when
adjusting the position of a locate point with the
rehearsal function. See page 32 for details about locate
point adjustment.
Â: the volume increases past the locate point.
µ: the volume decreases past the locate point.
During rehearsal mode, press the = or + key to
switch between increased or decreased volume after the
locate point.
Display brightness setting (Dimmer)
Adjusts the display brightness. You can choose from 8
levels (1~8). Larger numbers provide a brighter
display.
Changing a Setting
Use the following operations to change the system
settings
1 Press SYSTEM.
[SYSTEM] appears in the display.
2 Turn the jog dial to display the item you want to
adjust.
The item blinks in the display.
3 Press ENTER.
The blinking moves to the right of the item.
4 Turn the jog dial to display the setting you desire.
5 Press EXIT.
The item starts blinking again.
6 Press EXIT again.
[SYSTEM] disappears from the display.
To reset this unit to the original factory
settings
1 Turn off the power to this unit.
2 Hold down SYSTEM while turning the power
back on.
The power comes on and “Initialized” appears in
the display. The system settings are reset to the
original factory settings.
Volume increases
Rehearsal
period
Locate point
Volume decreases
Locate point
Rehearsal
period
3
5,6
2,4
1