Filter
Top Products
14
GB
Processor Operations
Adjusting the Surround Effect Level
(for Digital Cinema Sound modes only*)
You can adjust the surround effect level. This control
lets you adjust the “presence” of the current Digital
Cinema Sound mode from 0% (no digital cinema
sound effects) to 100% (150%) in 5% steps.
* This adjustment is not possible in the NORMAL
SURROUND or ENHANCED SURROUND mode.
1 Start playing a programme source.
2 Press DIGITAL CINEMA SOUND - MODE on the
remote repeatedly to select the mode you desire.
3 Press EFFECT + or – on the remote to select the
level you prefer. The effect level is indicated in
the display during adjustment. The level is stored
automatically.
Note
Changing the effect level may not produce major variations
in the surround effect when used with certain playback
sources.
z You can also adjust the surround effect level using
the controls on the front panel.
Use the MENU and the +/– knobs to adjust the
surround effect level parameter in the SURROUND
menu.
See page 15 for details on menu operations and the
surround effect level parameter.
Compressing the dynamic range (MPEG or
Dolby Digital (AC-3) only)
When inputting a MPEG or Dolby Digital (AC-3) signal
you can compress the dynamic range of the sound
track by using the dynamic range compression
parameters in the SURROUND menu. This may be
useful when you want to watch movies at low volumes
late at night. See page 15 for details on menu
operations and page 16 for details on the dynamic
range compression parameter.
Digital Recording
This processor makes it easy to make digital recordings
from the components connected to the processor. You
don’t have to connect playback and recording
components directly.
Before you begin, make sure you’ve connected all
components properly.
ç: Signal flow
EXAMPLE: Recording a CD using a DAT deck
See your DAT or CD player’s instruction manual if you
need help.
1 Press DIGITAL 1 (if a CD player is connected to
the DIGITAL 1 INPUT) to select the CD player.
2 Insert a blank digital audio tape into the DAT for
recording.
3 Start recording on the DAT and then start playing
the CD you want to record.
Note
You cannot record the digital signal from a MPEG or Dolby
Digital (AC-3) programme source.
INPUT buttons
Playback component
(CD player, etc.)
ç
ç
Digital recording
component
(DAT deck, MD
deck , etc.)