Filter
Top Products
8
GB
Getting Started
Speaker Set Up
To obtain the best possible surround sound, first
specify the type of speakers you have connected and
their distance from your listening position. Then use
the test tone to adjust the speaker volumes to the same
level.
Specifying the speaker type and distance
1 Press U (POWER) on the front panel to turn on
the processor.
2 Press SET UP.
“SP.SETUP” appears in the display
3 Press SET UP repeatedly to select the parameter
you want to adjust.
4 Turn the +/– knob to select the setting you desire.
The settings is entered automatically.
5 Repeat steps 3 and 4 until you have set all of the
parameters shown below.
6 Press SET UP to exit the set up mode.
Front speaker size
Initial setting is : FRONT SP [LARGE]
• If you connect large speakers that will effectively
reproduce bass frequencies, select “LARGE”.
• If you connect small speakers with minimal bass response,
select “SMALL” to activate the Dolby Digital (AC-3) bass
redirection circuitry and output the front channel bass
frequencies from the sub woofer or other “LARGE”
speakers.
Centre speaker size
Initial setting is : CENTER SP [LARGE]
• If you connect large speakers that will effectively
reproduce bass frequencies, select “LARGE” (WIDE
mode).
• If you connect small speakers with minimal bass response,
select “SMALL” to activate the Dolby Digital (AC-3) bass
redirection circuitry and output the centre channel bass
frequencies from the front speakers, sub woofer or other
“LARGE” speakers (NORMAL mode).
• If you do not connect the centre speaker, select “NO”
(PHANTOM mode).
Rear speaker size
Initial setting is : REAR SP [LARGE]
• If you connect large speakers that will effectively
reproduce bass frequencies, select “LARGE”.
• If you connect small speakers with minimal bass response,
select “SMALL” to activate the Dolby Digital (AC-3) bass
redirection circuitry and output the rear channel bass
frequencies from the sub woofer or other “LARGE”
speakers.
• If you do not connect rear speakers, select “NO” (3 CH
mode).
Rear speaker position
Initial setting is : REAR SP [ SIDE ]
This parameter lets you specify the location of your rear
speakers for proper implementation of the Digital Cinema
Sound VIRTUAL REAR SHIFT and VIRTUAL MULTI REAR
modes. Refer to the illustration below.
• Set to SIDE if the location of your rear speakers
corresponds to section A.
• Set to BEHIND if the location of your rear speakers
corresponds to section B.
This setting effects only the VIRTUAL REAR SHIFT and
VIRTUAL MULTI REAR modes.
+/–
90°
20°
A
B
45°
B
A
U
SET UP