Filter
Top Products
TASCAM DR-680
23
3 – Preparations
Turning the built-in speaker output
on and off
When shipped new from the factory, this unit's built-in
speaker output is set to on. To turn the built-in speaker
output off, set the
SPEAKER
item on the
GENERAL
page
to off.
1. Press the MENU button to open the
GENERAL
page of
the
MENU
screen.
2. Use the DATA wheel to select the
SPEAKER
item, and
press the ENTER/MARK button.
3. Use the DATA wheel to select one of the following
settings.
Options: OFF, ON (default)
4. Press the MARK (.) button to return to item
selection on the
MENU
screen.
5. Press the HOME/DISP button to return to the Home
Screen.
CAUTION
Before using the built-in speaker, turn the PHONES
knob to the minimum volume. Failure to do so could
cause sudden loud noises to occur, which might
damage your hearing or equipment.
NOTE
When headphones are connected, no sound is output
from the speaker.
Connecting monitoring equipment
To monitor with headphones, connect them to the
PHONES jack. Use the PHONES knob to adjust the
headphones volume.
Headphones
CAUTION
Before connecting headphones, turn the PHONES knob
to the minimum volume. Failure to do so could cause
sudden loud noises to occur, which might damage
your hearing or equipment.
To monitor with an external monitoring system (powered
monitor speakers or an amplifier and speakers), connect it
to the LINE OUTPUTS jack.
Powered monitor speakers
or amplifier and speakers
CAUTION
Before using an external monitoring system, turn
the volume to minimum. Failure to do so could cause
sudden loud noises to occur, which might damage
your hearing or equipment.
Adjusting the display contrast
Turn the VALUE/MARK knob while pressing and holding
the HOME/DISPLAY button to adjust the display contrast.