Filter
Top Products
11
Panel Controls and Terminals
■ Rear Panel
!3 MIDI OUT Terminal
This is for connection to the MIDI IN terminal of another
MIDI device (such as a MIDI tone generator, sequencer or
computer that has a MIDI interface), for sending MIDI
messages to that device.
!4 FOOT SWITCH Jack (1/4” phone)
This is for connection of a pedal switch (such as the
optional Yamaha FC4 or FC5). The default control for the
Footswitch is sustain on/off (Controller #64). It can be set
to control other functions; see on page 28 for details.
NOTE
■
Make sure that the Footswitch plug is properly
connected to the FOOT SWITCH terminal before
turning on the power.
■
Do not press the Footswitch while turning the power
on. Doing this changes the recognized polarity of the
Footswitch, resulting in reversed Footswitch operation.
!0 POWER Switch
Push this switch in to turn on the power. Each time the
power is turned on, the CBX-K2 returns to the default
condition. (See boxed section on page 10.)
!1 DC IN Terminal
This is for connection to a PA-1D AC adaptor or another
adaptor recommended by Yamaha.
!2 MIDI IN Terminal
This is for connection to the MIDI OUT terminal of another
MIDI device (such as a MIDI keyboard, sequencer or
computer that has a MIDI interface), for input of that
device’s data. By using the MIDI Merge function, received
data can be combined with the data generated by the CBX-
K2 and transmitted via the MIDI OUT terminal.
!0 !1 !2 !3 !4