Filter
Top Products
25
Setting a Specific Value for a Specific
Controller
Operation: C + ç → Function Key →
Controller Number → L → {Value(s) → L }
Relevant Functions: RPN Direct Data Send*; Controller
Direct Data Send; NRPN Direct Data Send*
Functions marked with an asterisk (*) above require
that you enter two values: an MSB (Most Significant
Byte) and an LSB (Least Significant Byte). (See on
page 21 and operation , page 23.)
●
Example:
Changing the Portamento Time of the tone generator’s voice
to 25.
C + ç → S → 5 (Portamento Time) →
K → {2 → 5 → K}
The operation steps enclosed in braces ({}) can be repeated
or re-entered as long as C is held.
NOTE
■
This operation transmits a value for the
specified controller number WITHOUT altering the
current controller assignment for the Assignable Wheel
or Assignable Slider.
Sending a Single-Byte Data Message
This function allows you to quickly and easily
send a non-standard MIDI message of a single
byte. The effective range of this function is from
0–255; values outside of this range will be
ignored.
Operation: C + ç → {Value → L}
Setting the Functions
Sending a Simple Command with L
Operation: C + ç → Function Key → L
Relevant Function: TG300B Reset
●
Example:
Sending the current CBX-K2 settings to a MIDI storage
device or sequencer with the Bulk Dump Out function
C + ç → ™ → L
Setting a Specific Value for a Function
Operation: C + ç → Function Key → Value →
L
Relevant Functions: Song Select; Voice Map; Device
Number; Touch Sensitivity; Data Density (Wheel); PB
Density; Data Density (Slider); Measure Number
●
Example:
Changing the touch sensitivity of the CBX-K2 to 10
C + ç → ˙ → 1 → 0 →
K
●
Example:
Sending a (decimal) value of 252
C + ç → {2 → 5 → 2 → K}
The operation steps enclosed in braces ({}) can be repeated
or re-entered as long as C is held.
NOTE
■
Decimal values of MSB and LSB are 3 digits
each (6 digits total); hexadecimal values are 2 digits
each. Zeroes must be entered, unless they occur at the
beginning of the value. For an example of MSB = 012,
LSB = 034 above, the first zero may be omitted, but the
second must be entered. In other words, the value
could be entered as 1
→
2
→
0
→
3
→
4
→
K.
11
12
13
14