Filter
Top Products
26
Group A Functions — List
● Footnotes
*1 The operation steps in braces ({}) can be repeated or re-entered as
long as C is held.
*2 Depending on the selected message or the particular device that is
connected to the CBX-K2, there may be no response. Refer to the
owner’s manual of the device for details.
*3 Be careful not to press the connected footswitch when footswitch is
assigned to “SUS”; the operation cannot be executed while the
footswitch is pressed.
*4 When Tempo is assigned to the Assignable Wheel or Slider, this
setting is ignored. When the Assignable Wheel or Slider is set to a
function other than Tempo, the current value is effective. The range
for this function is 20 – 300 bpm; when the Wheel or Slider is set to
control Tempo, the range is slightly narrower: 28 – 282 bpm. When
this is set to 0, “oFF” is shown in the display.
*5 The entry order of the MSB and LSB values can be changed by using
the MSB 1ST/LSB 1ST in Group B.
*6 The actual program change number transmitted by the CBX-K2 is the
displayed number minus one. For example, program number 001 on
the display is actually transmitted as 000.
*7 The value can also be easily increased or decreased. First, make sure
that the display is set appropriately (to Program Change or Bank
Key Panel Name Function name Operation (press and hold [SHIFT]) *1 Operation Examples
C1 SEQUENCER STOP Stop C + Q
C#1 CONTINUE Continue C + W
D1 START Start C + E
D#1 TEMPO Tempo C + R → (tempo value) → L
E1 PROGRAM BANK SELECT Bank Select C + T → (MSB) → (LSB) → L
F1 PROGRAM CHANGE Program Change C + Y →
(program change number) → L
F#1 RESET GM ON GM System On C + U → L
G1 ALL SOUND OFF All Sound Off C + I
(current channel)
G#1 XG ON XG System On C + O → L
A1 SYSTEM MERGE ON/OFF Merge On/Off(all channel) C + P
A#1 MIDI CH MIDI Transmit channel C + { → (channel number) → L
B1 FIXED VELOCITY Fixed Velocity C + } → (velocity value) → L
C2 WHEEL ASSIGN RPN Wheel Assign (RPN) C + A → (MSB) → (LSB) → L
C#2 CONTROLLER Wheel Assign C + S → (controller number) → L
(controller number)
D2 NRPN Wheel Assign (NRPN) C + D → (MSB) → (LSB) → L
D#2 DRUM NUMBER Drum Number (Wheel) Select the desired drum sound from the keyboard (page 23)
then press C + F → L
E2 TRANSPOSE Q Transpose Down C + G → {G} →
....(press repeatedly)
F2 W Transpose Up C + H → {H} →
....(press repeatedly)
F#2 SLIDER ASSIGN RPN Slider Assign (RPN) C + A → (MSB) → (LSB) → L
G2 CONTROLLER Slider Assign C + S → (controller number) → L
(controller number)
G#2 NRPN Slider Assign (NRPN) C + D → (MSB) → (LSB) → L
A2 DRUM NUMBER Drum Number (Slider) Select the desired drum sound from the keyboard (page 23)
then press C + F → L
D#3 DISPLAY PROGRAM CHANGE Display Program Change C + Y → L
E3 BANK MSB Display Bank Select MSB C + ¢ → L
F3 BANK LSB Display Bank Select LSB C + ¶ → L