Filter
Top Products
12
Your CBX-K2 will run from the included power adaptor,
PA-1D or an equivalent. Batteries can also be used (see
below). However, we strongly recommend that you use the
power adaptor.
NOTE
■
Before making any connections, make sure that
all equipment to be connected is turned off.
Using Batteries
To use the CBX-K2 on battery power, remove the battery
compartment cover (as shown below) and insert six 1.5V
AA size (SUM-3, R-6 or equivalent) batteries in the battery
compartment. Make sure to follow the polarity indications
on the bottom case.
Power Supply
Securely replace the battery compartment cover when done
installing the batteries.
When to Replace the Batteries
When the battery power runs too low to properly operate
the CBX-K2, an “E1” message appears in the LED display.
When this happens, replace all batteries with a complete set
of six new batteries of the same type.
CAUTION!
■
NEVER mix old and new batteries or
different types of batteries! Also, to prevent possible
damage due to battery leakage, remove the batteries
from the instrument if it is not to be used for a long
time.
Using a Power Adaptor
Connect one end of the power adaptor (PA-1D) to the DC
IN jack on the rear panel, and the other end to a suitable
electrical outlet.
CAUTION!
■
Do not attempt to use a power adaptor
other than the PA-1D (or another adaptor recom-
mended by Yamaha) . The use of an incompatible
adaptor may result in irreparable damage to the CBX-
K2, and even pose a serious shock hazard.
■
Be sure to disconnect the power adaptor from the
outlet when the CBX-K2 is not in use.
Power adaptor
STANDBY (?)
DC IN
Setting Up the CBX-K2 in Your Music System
Whatever your system, you should follow the basic instructions below when setting up your CBX-K2. Use
the example illustrations as a general guide when making the connections with your own system.
Guided Tour
Battery compartment cover
Guided Tour