Filter
Top Products
Master Settings—Master Edit
CP300 Owner’s Manual
54
Reference
Parameters
For assigning specific functions to each [ZONE
CONTROL] slider.
Setting targets: Zone 1, Zone 2, Zone 3, Zone 4
Functions/range: Volume, Modulation, Brightness, Harmonic
Content, After Touch, Control numbers 001 – 031, 033 – 095, Off
Default setting: Volume
n If you select After Touch or control numbers 001 – 031,
033 – 095, the slider affects only connected MIDI
instruments and not the CP300 itself.
You can select specific Voices or programs on a connected
MIDI device by specifying a Bank Select MSB value, in
combination with the Bank Select LSB and Program
Change parameters below.
Setting targets: Zone 1, Zone 2, Zone 3, Zone 4
Setting range: 0 – 127
Default setting: 0
The three specified MIDI messages—Bank Select MSB, Bank
Select LSB and Program Change—will be transmitted in the
following conditions:
• When turning on the Master mode.
• When changing any of the values of Bank Select MSB, Bank
Select LSB or Program Change when the Master mode is on.
• When selecting a Performance which was saved with the
Master mode on.
You can select specific Voices or programs on a connected
MIDI device by specifying a Bank Select LSB value, in
combination with the Bank Select MSB parameter (above)
and the Program Change parameter (below).
Setting targets: Zone 1, Zone 2, Zone 3, Zone 4
Setting range: 0 – 127
Default setting: 0
The three specified MIDI messages—Bank Select MSB, Bank
Select LSB and Program Change—will be transmitted in the
following conditions:
• When turning on the Master mode.
• When changing any of the values of Bank Select MSB, Bank
Select LSB or Program Change when the Master mode is on.
• When selecting a Performance which was saved with the
Master mode on.
You can select specific Voices or programs on a connected
MIDI device by specifying a Program Change number, in
combination with the Bank Select MSB and Bank Select
LSB parameters above.
Setting targets: Zone 1, Zone 2, Zone 3, Zone 4
Setting range: 1 – 128
Default setting: 1
The three specified MIDI messages—Bank Select MSB, Bank
Select LSB and Program Change—will be transmitted in the
following conditions:
• When turning on the Master mode.
• When changing any of the values of Bank Select MSB, Bank
Select LSB or Program Change when the Master mode is on.
• When selecting a Performance which was saved with the
Master mode on.
Slider Settings
Bank Select MSB Settings for MIDI
Transmission to an External Tone Generator
Slider
Zone 1 Volume
NO YES
A
B
DC
SendBankMsb
Zone 1 0
NO YES
A
B
DC
Bank Select LSB Settings for MIDI
Transmission to an External Tone Generator
Program Change Number Settings for MIDI
Transmission to an External Tone Generator
SendBankLsb
Zone 1 0
NO YES
A
B
DC
SendPG#
Zone 1 1
NO YES
A
B
DC