Yamaha PSR-3000 Musical Instrument User Manual


 
Voice Creating—Sound Creator
PSR-3000/1500 Owner’s Manual
101
Using, Creating and Editing Voices
VOLUME/ATTACK
EFFECT/EQ
Same parameters as in the SOUND CREATOR “EFFECT/EQ” tab display explained
on page 98.
VOL Adjusts the overall volume of the Organ Flutes. The longer the
graphic bar, the greater the volume.
RESP Affects both the attack and release (page 97) portion of the sound,
increasing or decreasing the response time of the initial swell and
release, based on the FOOTAGE controls. The higher the value, the
slower the swell and release.
VIBRATO SPEED Determines the speed of the vibrato effect controlled by the Vibrato
On/Off and Vibrato Depth above.
MODE The MODE control selects between two modes: FIRST and EACH.
In the FIRST mode, attack is applied only to the first notes played
and held simultaneously; while the first notes are held, any subse-
quently played notes have no attack applied. In the EACH mode,
attack is applied equally to all notes.
4', 2 2/3', 2' These determine the attack sound volume of the ORGAN FLUTE
Voice. The 4', 2-2/3' and 2' controls increase or reduce the volume
of attack sound at the corresponding footages. The longer the
graphic bar, the greater the attack sound volume.
LENG Affects the attack portion of the sound producing a longer or shorter
decay immediately after the initial attack. The longer the graphic
bar, the longer the decay.
Disabling automatic selection of Voice Sets (effects, etc.)
Each Voice is linked to its related parameter settings that are indicated in the
SOUND CREATOR displays, including effects and EQ. Usually these settings
are automatically called up when a Voice is selected. However, you can also
disable this feature by the operation in the relevant display as explained
below.
For example, if you want to change the Voice yet keep the same Harmony
effect, set the HARMONY/ECHO parameter to OFF (in the display explained
below).
You can set these independently by keyboard part and parameter group.
1 Call up the operation display.
[FUNCTION] [E] REGIST.SEQUENCE/FREEZE/VOICE SET TAB [
®
]
VOICE SET
2 Use the [A]/[B] buttons to select a keyboard part.
3 Use the [4
ππ
ππ
]–[7
ππ
ππ
] buttons to enable/disable automatic calling
up of the settings (ON or OFF) independently for each parameter
group.
Refer to the separate Data List for a list of parameters contained in each
parameter group.