Filter
Top Products
Using a Microphone (PSR-3000)
Adjusting the Microphone and Harmony Sound
PSR-3000/1500 Owner’s Manual
183
Adjusting the Microphone and Har-
mony Sound
1 Press the [MIC SETTING/VOCAL HARMONY] button.
2 Press the [I] (MIC SETTING) button to call up the MICROPHONE SET-
TING display.
VIBRATO RATE Sets the speed of the vibrato effect. Also affects the lead vocal
sound when the LEAD GENDER TYPE above is set to other than
Off.
VIBRATO DELAY Specifies the length of the delay before the vibrato effect begins
when a note is produced. Higher values result in a longer delay.
HARMONY1/2/3 VOLUME Sets the volume of the first (lowest), second, and third (highest)
harmony notes.
HARMONY1/2/3 PAN Specifies the stereo (pan) position of the first (lowest), second,
and third (highest) harmony notes.
Random
The stereo position of the sound will change randomly when-
ever the keyboard is played. This is effective when the Har-
mony mode (page 186) is set to “VOCODER” or “CHORDAL.”
L63>R – c – L>R63
A setting of L63>R pans the sound hard left, while 0 is at cen-
ter, and L<R63 is at hard right.
HARMONY1/2/3 DETUNE Detunes the first (lowest), second, and third (highest) harmony
notes by the specified number of cents.
PITCH TO NOTE When this is set to “ON,” you can “play” the voices of the PSR-
3000/1500 with your voice. (The PSR-3000/1500 tracks the pitch
of your voice and converts it to note data for the tone generator.
Keep in mind, however, that dynamic changes in your voice do
not affect the volume of the tone generator.)
PITCH TO NOTE PART Determines which of the PSR-3000/1500 parts will be controlled
by the lead vocal when the Pitch to Note parameter is “ON.”
2
1