Filter
Top Products
No sound or very low volume.
•Is the [POWER] switch set to ON?
Turn power on, as described in the section
"Preparations" (page 8).
•
Is [OUTPUT] jack connected correctly
to the playback system?
Make connections as described in "Getting
Connected" (page 7).
• Is there a problem with the shielded
cable?
Try using another cable.
• Is the connected playback system
operating normally and is the volume
setting appropriate?
Check the system and make sure that the
level is adjusted properly.
•Is [OUTPUT LEVEL] control of MRT-3
set correctly?
Set the control to a suitable position.
Sound is distorted or intermittent.
• Is output level of MRT-3 set too
high?
Set [OUTPUT LEVEL] control of MRT-3
to a suitable position.
Cannot record pattern.
• Is MRT-3 set to mode other than
pattern mode?
Activate pattern mode (
➝
p. 14).
•Is memory capacity limit reached?
Check remaining memory capacity(
➝
p.
39), and delete unneeded patterns and
songs.
Song cannot be recorded.
• Is MRT-3 set to mode other than
song mode?
Activate song mode (
➝
p. 33).
•Is memory capacity limit reached?
Check remaining memory capacity(
➝
p.
39), and delete unneeded patterns and
songs.
Playback sound is not in stereo.
• Is Y cable connected to [OUTPUT
STEREO/PHONES] jack?
Make connections as described in "Getting
Connected" (page 7).
• Is the panning setting appropriate?
Check whether the pan parameter for the
instrument sounds in the currently used kit
is set properly (
➝
p. 28).
FS01 has no effect.
• Is foot switch connected correctly to
the [FOOT SW] jack?
Make connections as described in "Getting
Connected" (
➝
page 7)
• Is correct function selected for
FS01?
Use [FUNCTION] key and pad 4 (FOOT
SW) to select the proper setting (
➝
p. 42).
ZOOM MRT-3
Troubleshooting
50
Troubleshooting
Check the following items first if there seems to be a problem with the MRT-3.