9 – Specifications : Messages and troubleshooting
108 TASCAM DM-3200 Owner’s Manual
✔
Clear this fader grouping?
Press ENTER to confirm,
or a cursor key to cancel.
Shown when the currently selected fader grouping is to be cleared.
✔
Clock Check Results
Current Fs: 48kHz
Sources
Word : 44.1kHz0.0%
Digi IN 1 : Out of Range
Digi IN 2 : Fs convert On
TDIF 1 : 44.1kHz0.0%
TDIF 2 : 44.1kHz0.0%
TDIF 3 : Unusable
ADAT : 44.1kHz+1.0%
SLOT 1 : 48kHz+0.2%
SLOT 2 : Unusable
Press ENTER to continue.
Results of performing a word sync check.
✖
Clock Info: WORD
No signal
Press ENTER to continue.
A clock source has been selected, but no signal is present.
✖
Clock Info: Digital In1
C-bit : Illegal data.
Press ENTER to continue.
Shown when badly-formed digital audio is received at one of the DIGITAL INs.
✔
Clock Info: INTERNAL
Fs: 44.1kHz
Press ENTER to confirm,
or a cursor key to cancel.
A valid clock source has been selected.
✖
Clock Info: Digital In1
Fs mode : Not indicated
Check D-IN MANUAL SETUP
Press ENTER to continue.
An attempt is made to use a clock source, but the sampling frequency cannot be
determined.
✖
Clock Info: WORD
New clock source is out of range.
Master clock is unchaged.
Press ENTER to continue.
A clock source has been changed, but the new clock is out of the permissible
range.
✔
COMP/EXP Library BANK a-bbb
Name : TASCAM DATA
Create data: DEC/15/2004
20: 35: 45
Project Name: PROJECT ORCA
Project FS: 44.1kHz
Press ENTER to continue.
Information about a library entry (compressor/expander).
✔
COMP/EXP Library Preset a-bbb
Name : TASCAM DATA
Press ENTER to continue.
Information about a library preset entry (compressor/expander).
✖
COMP/EXP Library
Preset 1-bbb is Read-only!
An attempt has been made to store to a protected library entry (compressor/
expander).
●
COMP/EXP Library
Bank a-bbb recalled.
A library entry has been recalled (compressor/expander).
●
COMP/EXP Library
Preset 1-bbb recalled.
A library preset entry has been recalled (compressor/expander).
●
Completed.
The selected operation (e.g. format or creation of project) has been completed
successfully
✔
Confirm LIST Auto Detect?
Press ENTER to confirm,
or a cursor key to cancel.
Confirming the auto-detection of machine control list
✔
Confirm TRA Auto Detect?
Press ENTER to confirm,
or a cursor key to cancel.
Confirming the auto-detection of transport control mapping.
Action Message Meaning
Table 9.2: Popup messages
