9 – Specifications : Messages and troubleshooting
TASCAM DM-3200 Owner’s Manual 115
●
Stored to Snapshot
Bank a-bbb
Stored a snapshot.
✔
The last stored project
cannot be found.
Create project?
Press ENTER to confirm,
or a cursor key to cancel.
At power-on, the last stored project cannot be found (maybe the card has been
changed).
✔
The current project is changed.
Store current project?
ENTER key : Store and Create
CURSOR key : Create
Changes have been made to the current project before a project creation.
✖
The project name has not been input.
An attempt has been made to create a project without giving it a name.
✖
There is no project loaded.
When storing, no project is currently loaded, so the data can’t be stored.
✖
This name is already assigned.
The name of the newly-created project already exists on the card as a project
name.
✖
This project is the current project
Can’t change.
The current project cannot be renamed
✖
This project is protected.
The project to be renamed is protected
✖
Timecode running!
An attempt has been made to create a project, etc. while timecode is still
running. Stop the timecode and try again.
✔
The current project
is not on the CF card.
Store the current project?
Cannot copy
automation data and library data
ENTER key : Store and Create
CURSOR key : Create
Confirmation that the current project should be stored on the card (it is not
already there). Automation and library data will not be stored.
●
Turn off power now.
Press ALT + STOP + PLAY to reboot.
The shutdown process is now complete, and the power can be turned off, or the
DM-3200 can be rebooted.
Action Message Meaning
Table 9.2: Popup messages
