Filter
Top Products
26
ADCC1100
Setting Scratch Pad Tours
To set a scratch pad tour:
1. Call a monitor to the keyboard.
2. Press the PROGRAM MODE tab key.
3. Press the KEYB CONFIG soft key.
4. Press the PROG S PAD soft key.
5. Enter a camera number for the first camera in the tour to be called to the monitor.
Press the ENTER soft key.
6. Enter a dwell time for the camera in seconds (1 - 60). Press the DWELL TIME
soft key.
7. Repeat steps 5 and 6 until all the cameras in the tour have been programmed.
8. Press the OPERATOR tab key to exit the scratch pad tour menu.
Dome Menu Functions
The ADCC1100 keyboard can be used to configure a suitable dome camera by
remotely accessing the dome camera's menu system.
To enter the dome camera menu:
1. Call the dome camera to the monitor.
2. Press the PROGRAM MODE tab key.
3. Press the DOME MENU (
MENU
) soft key. The dome camera's configuration menu will
appear on the active monitor.