Filter
Top Products
41
Keyboard Installation and Operation
Program Mode MacrosOperator
Site
Home
Up
Home
Down
Read
SC
Prog
SC
Site
Up
Site
Down
Start
Cam
End
Cam
Start End
1
2
3
4
5
6
7
8
9
1
257
512
1024
2315
3000
5100
6500
- - - -
256
500
675
1200
2540
3100
5250
6550
- - - -
H
Figure 5.2: Quicksite Configuration Menu
5. Press the QUICKSITE CONFIG soft key. The Quicksite configuration menu is
displayed (figure 5.2).
In this menu, configure the different sites in the system using the following procedures:
Configuring Satellite Sites
To configure the settings for satellite sites:
1. Using the SITE UP and SITE DOWN soft keys, move the arrow cursor to the site
which is to edited.
2. To specify the pseudo number of the first camera at this site, use the numerical
keys to enter the required camera number and press the START CAM soft key.
3. To specify the pseudo number of the last camera at this site, use the numerical
keys to enter the required camera number and press the END CAM soft key.
Important Note: The pseudo numbers programmed to the keyboard must match
the pseudo numbers programmed to each individual matrix site.
4. Repeat steps 1 to 3 to configure each satellite site. Up to nine sites can be
included. Camera numbers from site to site do not need to be sequential (as
illustrated in the figure above), but the camera numbers cannot overlap.
To clear a site, move the cursor to the required site, enter a 0 on the numerical
keypad and press either the START CAM or END CAM soft key.
5. Once the camera numbering has been configured, it is necessary to specify a
home site for the keyboard in use. The home site is the site to which the
keyboard is directly connected.
To specify the keyboard's home site, use the HOME UP and HOME DOWN soft
keys to move the H marker to the required site.
6. To store the settings to a smart card, press the PROG SC soft key.
7. The keyboard will display the message "Please Replace Smart Card". Insert the
smart card to be programmed and wait until the process is completed.