Filter
Top Products
B-1
Cisco RPS 675 Redundant Power System Hardware Installation Guide
78-15201-04
APPENDIX
B
Connector and Cable Specifications
This appendix describes the cable connector that is used to connect the Cisco
Redundant Power System (RPS) 675 to a supported device. The cable
(CAB-RPS-1614=) is a 48-inch (1.2-meter) cable with a 16-pin connector on one
end and a 14-pin connector on the other end.
Figure B-1 and Figure B-2 show the
connectors, and Table B-1 contains the pinout information.
Note The connector is keyed to insert into the receptacle only in its correct orientation.
Figure B-1 14-Pin Connector Pinouts
14 13 12 11 10 9 8
1234567
Top of Connector (Logo Side)
50211