Filter
Top Products
57. 2TRACK to MASTER
This control is used to add the 2TRACK signal to the main mix; post fader of the master
controls. Caution: When setting the level of the device that is connected to the 2TRACK
RETURNS – e. g. CD player, tape deck, etc. – always begin with the 2TRACK to MASTER
control set at its minimum setting; all the way counterclockwise. Otherwise, depending on
the output quality of the connected sound source, the outputted level can instantly “hit the
top”.
58. 2TRACK to AUX 3/4
The signal coming from the 2TRACK RETURN is internally summed and can be added to
the monitor bus using the 2TRACK to AUX3/4 control.
59. MASTER OUT
The mixer’s electronically balanced main outputs carrying the post master fader L/R signals
for connection of the main PA. The MASTER outputs are switched via output relay with a
delay of approx. two seconds after the mixer has been powered on, which prevents power-
on noise when switching the mixer on or off.
Please also refer to the chapter “Setting up a standard PA system”.
60. MASTER INSERTS
Stereo phone jacks for left and right channels with breaker function. The low impedance
output is assigned to the tip (send) and the high impedance input (return) is assigned
to the ring of the connector. This jack allows incorporating external third octave band or
octave band EQs, compressors, limiters, de-noisers, etc. into the master’s signal path.
The insertion point is pre master faders. As well as with the inserts of the monaural input
channels, different DIRECT OUT functions can be accomplished. Please, also refer to the
corresponding paragraph in the description of the MONO INPUT.
61. FOOTSWITCH
Phone jack for the connection of an optionally available DYNACORD FS11 (110 693)
footswitch to switch the effect mode of the internal FX units on or off. To accomplish this
function, the FX1 and FX2 ON switches have to be engaged. To remotely control the effects
units using only a single footswitch, the FS11 has to be connected to the FX1/GLOBAL
connector. Both FX units are simultaneously switched. This function is useful for example
when switching from vocal performance to announcer. When remotely controlling the FX
units using two footswitches, one FS11 needs to be connected to the FX1/Global and the
other to the FX2 connector. Now, the two effects units can be switched independently, which
is mostly used to switch between different effects settings during a performance.
62. LAMP XLR
This XLR-type socket provides a DC voltage of 12V/5 watts
and is meant for the connection of a gooseneck lamp (litlite).
The output is protected against short-circuit and overload.
Please make sure that the illuminant used complies with
the here mentioned specifi cations and pin assignment
of the XLR-type connector. We recommend using the
gooseneck lamp (112 850) and the replacement illuminant (350 278), both available from
the DYNACORD accessory assortment. For further information, please consult your local
dealer.
MASTER
19