Filter
Top Products
42
Mixer Functions
2
3
4
5
6
1
Blinking
1
2
Effect send level setting screen
Effect type/parameter setting screen
Effect send pre/post setting screen
<Hint>
In effect editing, pressing the [EFFECT] key switches the
setting screen shown on the LCD display in the following
order. “Effect send level setting screen” -> “Effect type/
parameter setting screen” -> “Effect send pre/post set-
ting screen”
On each screen, you can edit parameters.
Setting effect send levels
You can set send levels from Tracks 1 through 6 to the
internal A.S.P. effect processor.
Press the [EFFECT] key to bring up the send level
setting screen.
If you have not edited any track parameter for effect
send, EQ or pan setting after turning on the power last
time, the message prompting to select a track ("Select
TRK!") blinks, as well as the [TRACK STATUS/TRACK SEL]
keys for Tracks 1 through 6 on the panel flash.
If you have edited any track parameter for effect send,
EQ or pan setting after turning on the power last time,
the icon for the previously edited track is highlighted,
showing that it can be edited.
Select the desired track by pressing the correspond-
ing [TRACK STATUS/TRACK SEL] key (or using the
[CURSOR </>] keys).
The icon of the selected track is highlighted, indicat-
ing that you can edit it.
In the default settings, the send levels for Tracks 1
through 6 are "00" while the level for Master is "80."
Use the [JOG] dial to adjust the send level value.
The knob icon also rotates according to the level value.
When the level is set to "00", no signal is sent to the effect
processor.
• Editable tracks: Tracks 1 through 6
• Level range: 00 through 99 in 1 step
• Default level: Tracks 1 through 6: 00, Master: 80
To edit the send level for another track, repeat steps 2
and 3 above.
To edit the effect send master level, press the [STA-
TUS/SEL] key of the master to highlight the master
level icon, and then use the [JOG] dial to edit the value.
The default level value is "80."
After completing send level settings, press the [EXIT/
NO] key.
The LCD display returns to the Normal screen.
Selecting an effect type
Press the [EFFECT] key to bring up the effect type/
parameter setting screen.
The first time you bring up the screen, "L01: Norm HALL"
is selected as the effect type.
From the second time on when bringing up the screen,
the previously selected effect type is selected.
Use the [JOG] dial to select the desired effect type.
You can select an effect type from among L01 through
L38.
When you select a type other than the current type, the
type blinks.