Filter
Top Products
90
Save/Load of Song data
Blinking
3
Blinking
While "SCSI" is blinking, press the [ENTER/YES] key.
The display shows the screen for selecting the
program to be loaded.
The backup number currently selected blinks, while
the data size of the program is shown. While a backup
number is blinking, you can select the desired
program to be loaded. If a disk has more than one
program saved, you can select the desired program
by using the [JOG] dial.
• You can also select "Eject" as well as programs to be loaded
in the condition above. To eject the disk, press the [ENTER/
YES] key after selecting "Eject".
Use the [JOG] dial to select the program to be loaded
and press the [ENTER/YES] key.
The display shows the screen for selecting the
destination program to which data is loaded.
In the default setting, "New PGM" is selected so that
the data is loaded to a newly created program.
You can select any existing program available on the
current drive by rotating the [JOG] dial besides "New
PGM". When selecting an existing program, the data
size of the program is also shown.
When you load the data to any existing program, the
backup data overwrites the existing data.
If you do not like to overwrite any track, select "New
PGM".
<Note>
If the current drive disk (destination disk of loading
data) does not have enough available space for
accepting the loaded data, The display shows "Disk
Full" and the returns to the screen shown when
carrying out step 3.
Use the [JOG] dial to select the load destination
program and press the [ENTER/YES] key.
The data load to the selected program starts.
The following screen example shows that the "B01"
data on the backup disk is now being loaded to "P02"
on the current disk. As the data load goes on, the
remaining data size shown on the screen counts down.
4
5
<Note>
You cannot abort the load operation before
completed using SCSI, unlike the load operation
using the S/PDIF signal.
When the load operation is completed, "Completed!"
appears, while the VF08 stops.
Press the [EXIT/NO] key (or the [STOP] key)
repeatedly until exiting the setup mode.
6
Loading from more than one disk
The following procedure shows how to load song
data saved to two SCSI disks.
Insert the first disk (Disk-1) to the SCSI device.
Carry out the same procedures as steps 1 through 3
described in the previous section "Loading from a
single disk".
The display shows the screen for selecting a program
loaded.
If the program is saved over more than one disks,
backup file number "B01" blinks, as well as the
recorded data size is shown.
• By using the [JOG] dial in this step, you can select "Eject"
as well as destination programs. To eject the disk, select
"Eject" and press the [ENTER/YES] key.
<Note>
If Disk-2 (the second disk when saving) is inserted
in mistake, the VF08 automatically recognized that
the wrong disk is set. The display shows "Wrong
Disk", followed by "Illegal No!", and the disk is
automatically ejected. Then, as the display shows
"Insert Disk", insert Disk-1.
Press the [ENTER/YES] key.
The display shows the screen for selecting the
destination program to which data is loaded.
In the default setting, "New PGM" is selected so that
the data is loaded to a newly created program.
3
1
2