Filter
Top Products
section
92
Appendix
4. Connectingthepedalandpowercables
Pass the pedal cable (extending from the back of the pedal
board) behind the back board, and through the aperture to
the front of the main body.
Connect the pedal cable to the PEDAL terminal on the base of
the main body, ensuring the notched plug faces the rear of the
instrument.
Whendisconnectingthepedal cable,pressand
hold the notch and pull the plug gently.
Connect the power cable l to the AC IN terminal on the base
of the main body, then pass the cable through the back board
aperture, and out to the rear of the instrument.
The illustration below shows the location of the PEDAL and AC
IN terminals on the underside of the main body.
PEDAL
AC IN
Front
Rear
With the pedal and power cables connected, attach the two
cable clamps k to the rear of the left and right side panels,
then x the cables in place to tidy their appearance.
5. Attaching the headphone hook (optional)
A headphone hook is included with the CA93/CA63 digital
piano and can be used to hang headphones when not in use.
If desired, attach the headphone hook to the underside of the
main body using the two tapping screws provided.
6. Adjusting the pedal support bolt
Turn the pedal support bolt anti-clockwise, extending the
bolt until it makes contact with the oor and supports the
pedals rmly.
When moving the instrument, always adjust or
remove the pedal support bolt, then readjust
whentheinstrumentisinitsnewposition.
Assembly Instructions (CA63 only)
Pedal cable
Power cable
Attach the cable clamps,
x the cables in place
Turn the bolt