Filter
Top Products
14
recalled even after storing the scene.
If the filter is enabled, you can disable recall of scene
data even after storing the scene.
9. Recall .....................................................................
This recalls the settings that were stored in a scene.
If you recall a scene, edit the EQ etc., and then press the
“Recall” button to recall once again, the unedited set-
tings (the mixer settings that were registered in the
scene) will be recalled.
10.OvrWrt...................................................................
This overwrites the current mixer settings onto the
selected scene number. Use this when you wish to
make minor changes to a scene, or to replace it with
another scene.
A guide function has been added for the pan and fad-
ers.
P2 MixView: Pan/fader scene
display
Refer to the D16 Owner’s Manual for details on 1–3.
4. Pan/fader guide ...............[ ]
These symbols show the difference between the actual
fader or pan locations and the values that are registered
in the scene.
When a scene is recalled, the current position of the fad-
ers may differ from the values registered in the scene.
In this case, selecting the item that you wish to adjust
will cause an indicator symbol to appear, showing the
approximate difference between the internal setting
value and the control.
Faders
: The fader position is more than 51 steps above the
internal value.
: The fader position is between 21–50 steps above the
internal value.
: The fader position is between 1–20 steps above the
internal value.
: The fader position matches the internal value.
: The fader position is between 1–20 steps below the
internal value.
: The fader position is between 21–50 steps below the
internal value.
: The fader position is more than 51 steps below the
internal value.
Pan
: The pan knob is more than 51 steps to the left of the
internal value.
: The pan knob is between 21–50 steps to the left of
the internal value.
: The pan knob is between 1–20 steps to the left of the
internal value.
: The pan knob matches the internal value.
: The pan knob is between 1–20 steps to the right of
the internal value.
: The pan knob is between 21–50 steps to the right of
the internal value.
: The pan knob is more than 51 steps to the right of
the internal value.
Part of the “SetUp” tab page has been changed.
P1 SetUp: Tempo and rhythm
settings
Refer to the D16 Owner’s Manual for details on 1–4 and
6.
5. RhythmVol ............................................. [000...100]
Specifies the volume of the rhythm. This volume will be
sent to the master LR bus if the [SOLO/MONITOR]
“Monitor” page “Rhythm” button is turned off. If this
button is on, the volume will be sent to the monitor LR
bus. (→D16 p.17)
7. Pattern Length, Pattern Position................................
This shows the length (number of measures) of the
rhythm pattern selected by “SelRhythm,” and the mea-
sure that is currently playing.
Example: (L4:1)... currently playing measure 1 of a
four-measure pattern
p.67–
1
3
2
4
9. TEMPO/RHYTHM
p.68–
1
7
3
6
4 5 2