Filter
Top Products
20
4 Begin recording.
Press the [PLAY] key of the D16V2 to begin play-
back, and the external MIDI sequencer will begin
recording in synchronization. At this time, adjust-
ing the D16V2 mixer parameters (fader, pan, EQ,
etc.) will cause the corresponding control change to
be transmitted from the D16V2, and recorded on
the external MIDI sequencer.
5 Stop the D16V2.
When you press the [STOP] key of the D16V2 to
stop playback, recording will also stop on the
external MIDI sequencer. D16V2 mixer operations
have now been recorded on the external MIDI
sequencer.
Example 2
Here’s how the mixer control data recorded in Example
1 (above) can be transmitted to the D16V2 to control its
mixer. Make connections in the same way as described
for Example 1.
1 Make synchronization settings on the D16V2 and
on the external MIDI sequencer.
Make the settings of Example 1 step 1.
2 Enable control change reception on the D16V2.
In the [SYSTEM] “MIDI” page, set MixerControl
“Control Change Recv” to ON.
3 Put the external MIDI sequencer in playback-
ready mode.
4 Start playback on the D16V2.
When you press the [PLAY] key of the D16V2 to
begin playback, the external MIDI sequencer will
begin playback in synchronization. The previously-
recorded mixer control data will be transmitted
from the MIDI sequencer, and the mixer values of
the D16V2 will change accordingly.
The following functions of the D16V2 support FAT16
DOS format.
CD, CD-R, and CD-RW are exceptions.
• WAV file import
• WAV file export
• System software update
If an external SCSI drive is connected to the D16V2 and
the drive list indicates “Unknown Disk” (i.e., if the
D16V2 cannot recognize the drive), you can use the fol-
lowing procedure to make the D16V2 recognize the
drive.
1 Connect the external SCSI device to the D16V2,
and use the “DiskUtil” page to initialize it.
(→D16 p.47)
2 Re-connect the external SCSI device (that you ini-
tialized in step 1) to your computer, and format
it. For details on how to do this, refer to the
owner’s manual of your computer.
• For Windows → select normal format and exe-
cute formatting.
• For Macintosh → select MS-DOS format and
execute formatting.
Note when using DOS for-
mat disks