Filter
Top Products
16
Refer to the D16 Owner’s Manual for details on 1–4.
5. Level................................ [99 Level, 8 Level, 1 Level]
Specifies the undo level. The data will be saved for the
specified number of previously-executed operations.
You can select the undo level from 99, 8, or 1 opera-
tions.
6. New.......................................................................
Scroll the list toward the newer data.
7. Old.........................................................................
Scroll the list toward the older data.
Some of the operations have been changed.
P1 InsASS: Insert effect insert
position/type setting
Refer to the “D16 Owner’s Manual” for details on 1, 2,
and 4.
3. InsertTo...................................................................
Selects the position at which the insert effect will be
inserted.
Press the “ ” button to access the dialog box, and
make settings. Press the “OK” button to finalize the set-
tings, or press the “Cancel” button to discard any
changes you made.
■ When “Assign” is set to “In”
Specifies the return channel.
3a. Input....................................... (In1...8, DrL, DrR)
This shows the analog inputs.
3b. Effect ....................................................... (1...8)
This shows the effect numbers.
3c. SelectCh .......................................... [1...16, Off]
This specifies the return channel of the effect out-
put.
■ When “Assign” is set to “Trk”
Specifies the channel into which the effect will be
inserted: → (effect) → (return=inserted channel).
3a. SelectCh.......................................... [1...16, Off]
Selects the mixer channel into which the effect will
be inserted.
If the “SelectEffType” is “2in2outx2,” only
odd-numbered channels can be selected for
“SelectCh.”
3b. Effect ....................................................... (1...8)
This shows the insert effect number.
3c. OutputCh......................................... [1...16, Off]
This shows the return channel of the effect output.
The same channel as “3a. SelectCh” will be shown.
“Rhythm Level” has been deleted from “P2 Monitor:
Monitor settings.”
Refer to the D16 Owner’s Manual for details on 1, 2,
and 4.
5. Rhythm ......................................................[On, Off]
Selects whether the internal rhythm sound will be sent
to the monitor LR bus or to the master LR bus.
On: The internal rhythm sound will be sent to the mon-
itor LR bus. It will not be sent to the master LR bus.
Off: The internal rhythm sound will be sent to the mas-
ter LR bus. It will not be sent to the monitor LR bus.
The volume of the internal rhythm is adjusted by
“RhythmVol” in the [TEMPO/RHYTHM] “Setup”
page.
19. INSERT EFFECT
p.79–
1
23
4
3a
3c
3b
21. SOLO/MONITOR
p.84
2
1
5
4