4.Pattern mode
4.Pattern mode
33
Saving a pattern (WRITE)
If you wish to keep the pattern data that you create, you must
perform this Write operation. When you perform the Write op-
eration, "Data Copy within a pattern" (p.31) will occur auto-
matically, depending on the pattern length.
If you intentionally want to discard your edits and revert to the
original pattern data, simply select a different pattern without
Writing.
1. If the pattern is playing, press the Stop/Cancel key to stop
playback. Use the cursor keys to make the parameter select
LEDs indicate PATTERN.
2. Press the WRITE key once (the key will blink). The pattern
number will blink in the display.
3. Rotate the dial to select the writing destination pattern num-
ber.
4. Press the WRITE key once again to write the data.
To cancel, press the Stop/Cancel key.
If the Global mode Memory Protect setting is on, it will not
be possible to Write. In this case, you must turn off the
Global mode Memory Protect setting before you execute
the Write operation.
Never turn off the power during the Write operation. This
can damage the data.