Filter
Top Products
8.Data
8.Data
45
Error messages
Data could not be written.
When writing a song to a different song number,
the maximum number of recordable events was
exceeded. Use the Clear Event operation to erase
unwanted events from the song (p.38).
Protect was turned "on" for the memory into which
you attempted to write data. In Global mode, turn
the Protect setting "oFF" (p.40).
When event-recording on a song, event data
memory has filled up. If you attempt to record ad-
ditional events, the "memory full" message will
appear immediately. Either use Clear Event to de-
lete unwanted events from a song, or record blank
data to clear the memory.
Restoring the factory set
data
The pattern and song data with which the EA-1mk
II
is shipped
from the factory is referred to as the "preloaded data," and you
can restore this preloaded data back into the memory of the
EA-1mk
II
.
When you do this, the patterns you created and the songs which
use these patterns will be erased, and replaced by the preloaded
data. If you wish to keep the patterns and songs you created,
you must save the data on a data filer etc. before you load the
preloaded data.
1. While simultaneously pressing the TRANSPOSE key and the
WRITE key, turn on the power.
2. The display will indicate "PLd," and the Play/Pause key will
blink.
3. To load the factory preloaded data, press the blinking Play/
Pause key.
This will require apporoximately 15 seconds.
To cancel, press the Stop/Cancel key.
When loading is complete, the EA-1mk
II
will return to its initial
state. After several seconds the display will indicate pattern
number "A01," and the EA-1mk
II
will be in Pattern mode.
Never turn off the power during the Load process. The
data may be damaged.
Specifications
System: Analog modeling
Number
of parts: 2 parts
Memory
capacity: 256 patterns, 16 songs
Effects: Distortion, Tempo Delay, Chorus/Flanger
Sequencer: Pattern
Maximum 64 steps per part
Motion sequence
One parameter for each part, 64 events
Song
Maximum 256 patterns per song
Maximum approximately 65,500 events for
event recording
Connectors: PHONES
Stereo phone plug
Nominal level: 21 mW + 21 mW (32 ohms)
OUTPUT (PART1/MIX, PART2)
Phone jacks: mono x 2
Nominal output level: -10 dBu
Output impedance: 1 k-ohms
AUDIO IN (phone jack: mono x 1)
Nominal input level: -10 dBu
Input impedance: 47 k-ohms
MIDI (IN, OUT, THRU)
Power supply: DC 9 V (AC adapter included)
Power
consumption: 5.5 W
Dimensions: 296 (W) x 220 (D) x 55 (H) mm
(with rubber feet)
Weight: 1.5 kg
Er.1
Er.2
Er.9
Full