Filter
Top Products
14 Chapter 2: Getting Started
VeniceU
Operator Manual
Electric fields
Should this product be used in an electromagnetic field that is amplitude modulated by
an audio frequency signal (20Hz to 20kHz), the signal to noise ratio may be degraded.
Degradation of up to 60dB at a frequency corresponding to the modulation signal may
be experienced under extreme conditions (3V/m, 90% modulation).
Connecting up
To ensure the correct and reliable operation of your equipment, only high quality,
balanced, screened, twisted pair audio cable should be used.
XLR connector shells should be of metal construction so that they provide a screen
when connected to the console and, where appropriate, they should have Pin 1
connected to the cable screen.
All Jack connector shells should be connected to the cable screen.
Audio connections
This section gives details of the audio connections of the VeniceU.
Table 1: Connector pinouts
Connector on rear
panel Example of plug Pinouts Example of socket
Male XLR chassis
connector (output)
1 = ground
2 = hot
3 = cold
Female XLR chassis
connector (mic input)
1 = ground
2 = hot
3 = cold
Pair of RCA
connectors (tape
in/out)
1 = ground
2 = signal
1/4” TRS Jack plug
(inserts)
1 (tip) = send
2 (ring) = return
3 (sleeve) =
ground
1/4” TRS Jack plug
(input, output)
1 (tip) = hot
2 (ring) = cold
3 (sleeve) =
ground
2
3
1
1
3
2
1
2
123
13