Filter
Top Products
Balance, mute and solo 53
VeniceU
Operator Manual
Balance, mute and solo
The VeniceU has balance, mute and solo on every multifunction input channel.
Balance, mute and solo sections of the multifunction input channels
Item Description
1 bal control knob This stereo line input balance control allows continuous
reciprocal adjustment of the channel’s stereo image. It allows the user to
determine the relative output power to each left and right output. At all
points this control retains constant power. The fully left and fully right
positions are +3dB and the centre position is 0dB.
However, when using the mic input the balance controls acts as a pan. The
fully left and fully right positions are 0dB and the centre position is -3dB.
2 MUTE switch and red LED The MUTE switch mutes the channel signal.
The mute LED illuminates to show when the MUTE switch is on.
3 SOLO switch and yellow LED With solo enabled, the channel signal is
sent to the after-fade listen (AFL) stereo and pre-fade listen (PFL) mono
buses. The left and right local monitor outputs can be used, for example,
when operating from within a booth to hear selected solos and not the
whole mix. The solo LED illuminates to show when a solo is on.
1
2
3