Filter
Top Products
54 Chapter 6: Multifunction Input Channel
VeniceU
Operator Manual
Fader, routing and meter
The VeniceU fader section has the following functions.
Fader section of the multifunction input channels
Item Description
1 LED meter These LEDs comprise the multifunction input channel meter,
which lets you monitor the input signal without having to use the PFL. The
meter will display the higher of the two signals (left or right). The red +18
LED will also show any overload activity on the USB.
Note: The LED meter is post-insert and post-EQ, but pre-fader and
pre-mute.
2 Fader This channel fader allows for continuous adjustment of the channel
level from 4 (infinity/off) to +10dB. At 0dB, the output of the channel to
the stereo, mono and group buses will be at unity, that is, no adjustment in
level from the input.
3 Group switches Two latching switches route its channel signal to any of
the four groups. Group sends are post-EQ, post-mute, post-fader and
post-balance.
4 mono switch This switch routes the channel signal to the mono master
bus (post-EQ and post-fader).
5 stereo switch Routes the channel signals to the stereo master buses
(post-EQ, post-balance, post-mute and post-fader).
2
1
4
5
3