Filter
Top Products
122
Troubleshooting
Even though you press only one
key, a multiple number of notes
sound
Harmony Intelligence is turned ON.
Turn “Harmony Intelligence” off.
p. 73
Chord Intelligence is turned ON.
Turn “Chord Intelligence” off.
p. 49
Pitch is off
Transpose is in effect.
Simultaneously press the Transpose [-]
[+] buttons to cancel the transposition
(the Transpose [-] [+] buttons’
indicators will go out).
p. 68
The tuning is incorrect.
Adjust the standard pitch.
p. 109
While set for an octave shift, you are
playing keys beyond the recommended
range.
Adjust the Octave Shift setting.
p. 35
Sound is distorted / cracke
The Part Balance volume of each part is
too high.
Press the Part Balance buttons to lower
the volume.
p. 34
The Reverb volume has been raised when
the volume of each Part Balance button is
already raised.
Either lower the Reverb volume, or
adjust the Part Balance of each part.
p. 34
p. 78
The [Master Volume] knob has been used
to raise the overall volume excessively.
Use the [Master Volume] knob to lower
the overall volume.
p. 17
The Bass Range Sounds Odd, or
There is a Vibrating Resonance
When listening through speakers:
Playing at loud volumes may cause
instruments near the ATELIER to resonate.
Resonance can also occur with
fluorescent light tubes, glass doors, and
other objects. In particular, this problem
occurs more easily when the bass
component is increased, and when the
sound is played at higher volumes.
Use the following measures to suppress
such resonance.
• Place speakers so they are 10–15
cm from walls and other surfaces.
• Reduce the volume.
• Move the speakers away from any
resonating objects.
- - -
When listening through headphones:
Here, a different cause (such as
resonance produced by the ATELIER)
would be suspect.
Consult your Roland dealer or nearest
Roland Service Center.
- - -
926b
The volume level of the instrument
connected to ATELIER is too low
Could you be using a connection cable
that contains a resistor?
Use a connection cable that does not
contain a resistor.
p. 116
Pressing the expression pedal
while playing back ATELIER
performance data produces a
crackling noise
The expression pedal function is set to
“PEDAL+COMPOSER” during playback
of ATELIER performance data.
When this setting is used, moving the
expression pedal while playing back
ATELIER performance data may create a
difference between the expression pedal
information in the performance data and
the volume as set with the expression
pedal, which can result in this kind of
sound being produced.
Set the expression pedal function to
“PEDAL” during playback.
p. 100
Problem Check Solution Page
AT-75_e.book 122 ページ ２００８年８月２１日 木曜日 午前１０時９分